Transmissions and DrivetrainNeed help with your trans? Problems with your axle?
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Alright, so the car has been in storage for a long while and the speedo worked fine. Now it does not. I pulled the driven gear to get a look, and it seems that the drive gear slipped up the shaft. I did all of this a long while ago, so I don't remember if I had a new clip or not. What is usually causes this so I can prevent it from happening again? I read a bad speedo cable can cause it? I can manually spin the end of cable, and the speedo moved, so It seems that the cable is fine. The only other thing I can think of is my torque arm came loose, and either the tail shaft or the torque arm were slamming into the bottom of the car under acceleration, or if I shifted too hard.
Anyways, I need to fix this, so can I take the tail shaft off with out removing the trans? And where can I get a new clip if mine is mangled?
This ad is not displayed to registered members. Register your free account today and become a member on ThirdGen!
__________________ Blue 5-Speed TPI 85' Z28 Hardtop 60,XXX Miles
mods: $6E '165 MAF ECM Swap, Hedman Shorties to a 2.5" cutout,LS1 Driveshaft, Zexel Torsen Posi, Center Force DF clutch, Hurst Short Throw Shifter, Comp 1.6 magnum rockers, Modified stock TPI w/ SLP runners, Sphon LCA, Panhard Bar, and SFCs, free mods
Sponsored Links
Registered users do not see this ad. Click here to register for free!
James, I want to commend you for always helping out without YELLING use the search, because the search is simple sometimes and worthless on other times
