3-4 snap ring on 700-R4
03-24-2012, 05:19 PM
#1
Junior Member
Thread Starter
Join Date: May 2010
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
3-4 snap ring on 700-R4
So I installed Alto 3-4 clutch pack in my tranny and there isn't enough clearance for the original setup. The kit came with a .062" snap ring to allow for the proper clutch clearance. My original snap ring is .093"
If I use the .062" ring obviously it has some slight free-play in the case groove. Has anyone had a problem with this snap ring breaking out of the groove because of the free-play? Should I go with a different backing plate and use the .093" snap ring?
If I use the .062" ring obviously it has some slight free-play in the case groove. Has anyone had a problem with this snap ring breaking out of the groove because of the free-play? Should I go with a different backing plate and use the .093" snap ring?
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
7
10-08-2015 08:34 PM
TMZIrocZ350
Engine/Drivetrain/Suspension Parts for Sale
1
10-07-2015 12:09 PM
[CA] 700R4 trans & parts
6998poncho
Engine/Drivetrain/Suspension Parts for Sale
0
09-25-2015 02:56 PM
