manual torque converter locking question about wiring
#1
Junior Member
Thread Starter
Join Date: Mar 2013
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 camaro berlinetta
Engine: carb'd lg4 305
Transmission: 700r4
Axle/Gears: 3.08's sonn to be 3.73's
manual torque converter locking question about wiring
so ive already searched and no one has asked this question, my torque converter has been locking at random points like at 10 mph today, so i want to wire in a manual switch and istill have my stock ecm so can i just do this and will it work the same as all the other ways of wiring one https://www.thirdgen.org/torqueswitch
#2
Supreme Member
iTrader: (13)
Join Date: Apr 2005
Location: Not in Kansas anymore
Posts: 7,732
Likes: 0
Received 11 Likes
on
11 Posts
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: manual torque converter locking question about wiring
All a switch wired that way does is ADD a manual option , does not bypass the existing ECM control
Instead of shadetreeing the problem, I would be investigating why ?
I would start by checking the tan / blk wire from the trans to the ECM ;if that randomly shorts to ground somewhere it will engage the lockup the same way your new switch would.
#3
Junior Member
Thread Starter
Join Date: Mar 2013
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 camaro berlinetta
Engine: carb'd lg4 305
Transmission: 700r4
Axle/Gears: 3.08's sonn to be 3.73's
Re: manual torque converter locking question about wiring
K so i was looking at the transmission and theres that wire harness with 2 wires comin out can i just cat those and run those wires to a switch
#5
Junior Member
Thread Starter
Join Date: Mar 2013
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 camaro berlinetta
Engine: carb'd lg4 305
Transmission: 700r4
Axle/Gears: 3.08's sonn to be 3.73's
Re: manual torque converter locking question about wiring
my bad i didnt jack it up on jackstands before, i do have three wires theres orange green and purple
#6
Junior Member
Thread Starter
Join Date: Mar 2013
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 camaro berlinetta
Engine: carb'd lg4 305
Transmission: 700r4
Axle/Gears: 3.08's sonn to be 3.73's
Re: manual torque converter locking question about wiring
can i just have pin b and pin d always grounded and then pin a connected to a 12v source. can i put a toggle switch on pin and just flip the switch on when i want to engage the torque converter
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM