Where do clutch lines go? T56
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Mar 2012
Location: Georgia
Posts: 574
Likes: 0
Received 6 Likes
on
4 Posts
Car: 91' Z28. 70' Dune Buggy
Engine: LSX Cam/Full Bolt ons
Transmission: T56
Axle/Gears: 4.10
Where do clutch lines go? T56
How does this work? The slave cylinder on my ls1/t56 has the two fittings for a line.
Where do I get this line?
Where does it go? Clutch master cylinder right?
I'm assuming I need two lines?
Sorry for my ignorance on this subject. Gotta learn someway right?
Thanks for any help.
Where do I get this line?
Where does it go? Clutch master cylinder right?
I'm assuming I need two lines?
Sorry for my ignorance on this subject. Gotta learn someway right?
Thanks for any help.
#2
Supreme Member
iTrader: (24)
Join Date: Jun 2005
Location: NC
Posts: 7,890
Likes: 0
Received 66 Likes
on
49 Posts
Car: 92 Firebird
Engine: Supercharged 6.0
Transmission: T56
Axle/Gears: 8.8 3.73
Re: Where do clutch lines go? T56
On the ls1 HTOB, upper port is bleeder, lower port connects to the master
The bleeder port should have either a long hex stub or line with a bleed screw on the end (speed bleeder)
The lower port should have a quick connect fitting. The line from the master to slave is quite expensive. I have a master/line Fs if you need one. Most vendors have speed bleeders available
The bleeder port should have either a long hex stub or line with a bleed screw on the end (speed bleeder)
The lower port should have a quick connect fitting. The line from the master to slave is quite expensive. I have a master/line Fs if you need one. Most vendors have speed bleeders available
Thread
Thread Starter
Forum
Replies
Last Post
Night rider327
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 04:17 AM