Swap done need help with wiring
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2003
Location: pnw near portland or.
Posts: 506
Likes: 0
Received 3 Likes
on
3 Posts
Car: 91 RS convertible
Engine: 330 hp vortec 350. TBI
Transmission: 5 Speed
Axle/Gears: 3.73 Moiser 12 bolt/Wilwood disc's
Swap done need help with wiring
OK I went from a 700r4 with a stoch shifter to a B&M Megga shifter so my wireing is a little butchered.
What 2 wires go to the netural safty switch on the clutch peddle?
then the other 2 go to the reverse lighgts rite? do I fish them through the floor to the switch on the side of the trans?
Finialy how do I hook up the clutch peddle to disengage the cruise when the clutch is depressed?
I read the T56 thread and it helped but it isn't exactly rite.
But on a good note the 5speed is a blast. Even befor I put a stick shift chip in.
I could not have done it with out the help of this form and the help of all you out there.
THANKS
What 2 wires go to the netural safty switch on the clutch peddle?
then the other 2 go to the reverse lighgts rite? do I fish them through the floor to the switch on the side of the trans?
Finialy how do I hook up the clutch peddle to disengage the cruise when the clutch is depressed?
I read the T56 thread and it helped but it isn't exactly rite.
But on a good note the 5speed is a blast. Even befor I put a stick shift chip in.
I could not have done it with out the help of this form and the help of all you out there.
THANKS
#2
Senior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2003
Location: pnw near portland or.
Posts: 506
Likes: 0
Received 3 Likes
on
3 Posts
Car: 91 RS convertible
Engine: 330 hp vortec 350. TBI
Transmission: 5 Speed
Axle/Gears: 3.73 Moiser 12 bolt/Wilwood disc's
Re: Swap done need help with wiring
On a bonus my speed O is dead on.
Thread
Thread Starter
Forum
Replies
Last Post