03-12-2002, 06:44 PM
|
#2 |
| Senior Member
Join Date: Jan 2002 Location: Moscow, ID I need my own machine shop
Posts: 3,852
Car: 82 Z28 Engine: Al LT1 headed LG4 305 Transmission: TH350 Axle/Gears: 3.73 posi with spacer | A th-350 is a bolt in for the th-200c they have the same dimensios. The only thing you will need i a torque arm bracket from B&M or Hurst. I don't even have a bracket and did some mods and fabrication on mine to make it really stiff.
__________________
LT1 headed LG4 305 beast! Comp Solid lifter XS-262-10S, 1.6 Roller Rockers, 10.2:1, Holley 4160 600cfm, modded Weiand 7502 intake to fit LT1 heads____ Custom cylinder head cooling. Weiand 8208 Short Water Pump____TH-350 3 series 3.73 with 2 series posi and spacer____ Hedman Hedders 1 5/8 headers and Y-pipe 3in Exhaust, Dynomax 3" Bullet muffler ____Moroso Ultra 40 Wires ACCEL HEI Super Coil ____Competition Engineering 3120 Bolt-on SFC's____Homemade: Wonderbar, solid tie rod sleeves, Aluminum LCA and Panhard Rod with spherical rod ends, alternator and PS bracket, Strut tower brace, and Decoupling torque arm with telescoping link.
3000lbs
"The liberty of a democracy is not safe if the people tolerate the growth of private power to a point where it becomes stronger than their democratic State itself. That, in its essence, is Fascism - ownership of government by an individual, by a group or by any controlling private power."
-FDR
"If this were a dictatorship, it'd be a heck of a lot easier, just so long as I'm the dictator."
-- President George W. Bush
During a photo-op with Congressional leaders on 12/18/2000. |
 
|  |
