V6Discussion and questions about the base carbureted or MPFI V6's and the rare SFI Turbo V6.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
i have a 1991 camaro RS with a 3100 V-6. I went to auto zone and bought some new valve cover gaskets, but, the problem is i don't know how to take the injector stuff off of the engine to get down to the valve covers. i don't know to much about taking injectors apart so any help will be appreciated.
On the thin sheet metal valve covers make sure the edge is good straight, not bent or wavy.
Take a hammer (tap lightly!) to the metal cover sealing edge to correct any previous damage, to get best gasket seal.
just did all that last night for a lifter
you gotta remove the intake and fuel rail
and you will probobly need to move your coil, and a pipe that runs into the egr
