92rs-350dfi

Hey guys. I want to buy a set of weld draglites for my 92 camaro. I found a pair on craigslist for cheap. They are 15X10with a 7.5 back space. Will they fit with out any problems?? No cutting or hammers! Thanks

This ad is not displayed to registered members. Register your free account today and become a member on ThirdGen!

Orr89RocZ

I think most people run 6.5" backspacing with those wheels and stock width rear ends. I have 15x8's with 5.5" backspacing with my wider 4th gen rear and it fits fine. Thirdgen rears run 4.5" backspacing with 15x8 wheel.

So those wheels you have will sit in another inch. Depending on the tire size you may get away with doing much. I know others have done it but not sure if much work was involved. Probly going to have to check inner fender well clearance. beat in the front lower metal abit, its soft and bends easily. That should help alot. With my setup I can tuck in another inch I think without problems. I run 26x11.50 ET street

__________________

1989 Twin Turbo IROC-Z
"Twin Turbo 401 Buildup Pics "
"FQuick Garage"
9.86 at 141 mph 14psi, street tune

kens86

those wheels are more based on 4th gen rears. they about 3 inches longer.

__________________
1986 Camaro. 383 SBC. Scat forged bottom end, Diamond Pistons, Bullet solid roller, Crower HIPPO Roller lifters, Motown heads that flow 320cfm, Comp Pro Magnum Rockers, Ported Hurricane Intake, TRC 950 Carb.
TH350, RMVB. ATI 8" converter.
Strange S60 With 4:11's and Detroit Locker. Strange Adj Shocks
All Spohn Suspension.
275/60/15 MT ET streets. Sportsman up front.

2000 Camaro SS. M6, SLP. Usual Bolt ons.
1966 Chevelle 427 4 speed.