"The Parts Place" Plastic T-Top Drip Edges - Poor
#1
Member
Thread Starter
iTrader: (1)
Join Date: Jul 2015
Location: Schaumburg, IL
Posts: 223
Likes: 0
Received 3 Likes
on
3 Posts
Car: 1992 Polo Green RS Z03
Engine: L03 - 5.0 Liter V8 TBI
Transmission: MD8 – 4 SPD Auto
Axle/Gears: GU2 - 2:73 Ratio
"The Parts Place" Plastic T-Top Drip Edges - Poor
In a previous review I commented about the Eckler's T-Top Drip Edges.
These sold by The Parts Place have to be made my the exact same supplier, functionality wise they are just fine. The construction is fine, the mounting tape is good, even the mounting clips are in the correct place, so if all you need a a well made functioning trim, this a good deal @ $49.00 w/ free shipping via eBay.
I rate them poor due to their visual appearance for restoration / preservation sake.
The exposed "flap" has an inconsistent texture, visible flow lines from casting, the corners are not rounded, and the edge is rough with injection mold dimples.
I will add pictures later.
These sold by The Parts Place have to be made my the exact same supplier, functionality wise they are just fine. The construction is fine, the mounting tape is good, even the mounting clips are in the correct place, so if all you need a a well made functioning trim, this a good deal @ $49.00 w/ free shipping via eBay.
I rate them poor due to their visual appearance for restoration / preservation sake.
The exposed "flap" has an inconsistent texture, visible flow lines from casting, the corners are not rounded, and the edge is rough with injection mold dimples.
I will add pictures later.
Thread
Thread Starter
Forum
Replies
Last Post
truckerz
Engine/Drivetrain/Suspension Parts for Sale
31
04-27-2016 11:25 AM
someone972
Tech / General Engine
17
04-12-2016 08:46 PM
MarkF
Engine/Drivetrain/Suspension Parts for Sale
5
04-08-2016 03:29 PM
1Aauto
Sponsored Vendors
0
04-06-2016 12:39 PM