I have a problem with my camaro. There is a section about an inch long that was dented in right above the drivers side mirror. I tried bondoing the spot smooth but when I went to put the molding on above it, it would not line up correctly. I was wondering is there a way to bend the metal back to its normal shape without using a hammer. Its bend down about a centimeter for an inch. Thanks


------------------
1991 Chevy truck 5.7 engine
Competition Cam 454 lift
Edelbrock Valve Springs
Holley Red Electric Fuel Pump
Eldelbrock Performer RPM Intake
Holley 750 Double Pumper
68 jets front 74 jets rear
Turbo 350 transmission
B&M shift kit
Custom drive shaft
3.73 Rear end
Flowmaster exhaust
No emissions or computer
Grant steering wheel
http://www.fbody.com/members/Camrs89/