W3 Problems
Thread Starter
Junior Member
Joined: Apr 2003
Posts: 58
Likes: 0
From: Prince George
W3 Problems
Hey everyone,
I have a 12" JL W3, the one with the connectors like this:
- anyways, I go to install it, and all I get is really quiet static, what's the problem? I think either the sub is blown, or maybe the wire i'm using is too thin? I've wired it a few ways, but this seems to be the "correct" way to make it 4ohms:
but still, the quiet static. aah! any suggestions?
I have a 12" JL W3, the one with the connectors like this:
- anyways, I go to install it, and all I get is really quiet static, what's the problem? I think either the sub is blown, or maybe the wire i'm using is too thin? I've wired it a few ways, but this seems to be the "correct" way to make it 4ohms: but still, the quiet static. aah! any suggestions?
Member
Joined: Mar 2004
Posts: 406
Likes: 0
From: Holland, MI
Car: '89 Black IROC 'vert
Engine: 305 TPI
Transmission: 700-R4
Axle/Gears: 2.73 posi
Make sure you bridged the correct channels on your amp. To test the sub, take a AA battery and hook the + wire to the + terminal on the battery, then - to -. You should see a little movement in the sub. If not, its dead.
Thread
Thread Starter
Forum
Replies
Last Post