The only hole in the firewall that i've been able to use for wiring has been the hole just over the brake pedal.

However, I would like to wire an amp to my stereo, and i need to run a 10 gauge wire to the trunk. Where can the wire be routed? I am not sure of where holes in the firewall can be drilled either.

I basically would like to know if anyone has used any other holes in the firewall, because frankly, i'm stumped.

Joe


------------------
86 IROC TPI 305
700-R4 with Trans-go shift kit
K&N Air filters
Dyno-Max cat-back
Summit tranny cooler
CEI throttle enhancer chip

 

I drilled a new hole in mine for my stereo wire. I drilled it just under the edge of the carpet toward the middle, which puts it out below the gauge stuff on the drivers side.
Hope this helps..
Douglas

 

What was on the engine side of the hole?

------------------
86 IROC TPI 305
700-R4 with Trans-go shift kit
K&N Air filters
Dyno-Max cat-back
Summit tranny cooler
CEI throttle enhancer chip