Can they be removed?
Thread Starter
Member
iTrader: (1)
Joined: Oct 2001
Posts: 100
Likes: 0
From: Marshallville, Ohio, USA
Car: 98 Camaro/85 Camaro
Engine: 3.8L/ 355 CI
Transmission: Auto/ TH350
Axle/Gears: 3.23 Posi
Can they be removed?
85 z28 carbed car. I just removed my ECU and engine harness over the weekend. There were two connectors that clipped to the side of the ECU mounting box. The wires on the engine harness side have been removed with the engine harness.
The wires connected on the other side of the two connectors appear to run under the dash towards the mess of wires under the guage pod area.
Question is: should/can I remove these or should I just secure them under the dash and forget about them? Where do they go to?
The wires connected on the other side of the two connectors appear to run under the dash towards the mess of wires under the guage pod area.
Question is: should/can I remove these or should I just secure them under the dash and forget about them? Where do they go to?
Supreme Member
iTrader: (3)
Joined: Jul 2004
Posts: 2,989
Likes: 9
Car: '91 Z28 convertible
Engine: TPI
Transmission: T5
Axle/Gears: 3.27 posi disc
Re: Can they be removed?
The best way (IMO) would be to secure them under the dash and let them be. These are the wires that connect your dash light and fuses to the ECM.
Hope this helps.
Lou
Hope this helps.
Lou
Thread
Thread Starter
Forum
Replies
Last Post