arick793

I have a 92 chevy block that has the factory provisions for a roller cam, but came with a flat tappet cam. I need EVERYTHING except for the camshaft. Lifters, spider, pushrods, and whatever else might be necessary. Thanks!

John in RI

iTrader: (167)

I'll see if I can pull out all this stuff sometime tomorrow. Not sure that I've still got all the little parts,....... so let me check first and then I'll update this post.

What's your ZIP code ??

arick793

That would be great! Whatever bolts and other hardware you can save would help a lot too. My zip code is 14621

dixie wrecked

iTrader: (6)

I've got a junk roller block that I'm using to fit. Won't need the spider and such, it's all there, lifters and all. However I won't be back in state till like the 3rd

midias

Nice another rochester area guy

arick793

Yup, but I'm driving a second gen Camaro now. The motor parts are third gen though

rarebmx

iTrader: (6)

In case you didn't know, you'll need new lifters, just smarter to buy brand new ones so they seat properly. & I'd personally buy new pushrods as well.

John in RI

iTrader: (167)

No Luck; I was thru the garage yesterday and couldn't find the spider and dog-bones..... I'm thinking that it's best to get all that stuff from one place so hopefully another member has all the stuff that your lookin' for. Good Luck !

transaero

iTrader: (6)

I haves lifter setup from a '97 Chevy pickup, it should be what you need. Have the lifter hold down plate, dog bones, cam retaining plate (and bolts), pushrods, and two set of roller lifters.

arick793

I was able to get the parts I need locally, thanks though.