Lower rad support sheet metal....
#1
Member
Thread Starter
Join Date: Mar 2005
Location: Milton Ontario Canada
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Camaro z28
Engine: 350 v8
Transmission: T5
Lower rad support sheet metal....
hey,
Im about to sandblast the undercarriage of my car and i have noticed the lower rad support is pretty much rotted out. Is there anywhere that remakes these to the right specs?
I Guess i could make one out of sheet metal or get one from a scrap yard but i doubt they will want to cut it off for a 10-20 dollar piece of steel.
Douglas
Im about to sandblast the undercarriage of my car and i have noticed the lower rad support is pretty much rotted out. Is there anywhere that remakes these to the right specs?
I Guess i could make one out of sheet metal or get one from a scrap yard but i doubt they will want to cut it off for a 10-20 dollar piece of steel.
Douglas
#2
Supreme Member
iTrader: (2)
Join Date: Dec 2000
Location: Buffalo, NY
Posts: 2,361
Likes: 0
Received 2 Likes
on
1 Post
Car: 1984 Trans Am
Engine: LT1
Transmission: T56
Axle/Gears: 10 bolt w/ 4.10 gears
Re: Lower rad support sheet metal....
I think a junkyard would be fine with cutting that out or you can cut it yourself at a yard that allows you to pull your own parts.
#3
Junior Member
Join Date: Feb 2005
Location: Central Wis.
Posts: 79
Received 0 Likes
on
0 Posts
Car: 1985 Z28
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3.23
Re: Lower rad support sheet metal....
Have you checked the General??I haven't bought one of these lately,but it may still be available from the dealership.When I bought all the front pieces to repair my car,they were pretty cheap.But,then again,it may be dis-continued.....BILL
Thread
Thread Starter
Forum
Replies
Last Post