Aluminum welder/fabricator in Denver
12-12-2014, 07:44 AM
#1
Senior Member
Thread Starter
iTrader: (5)
Join Date: Jan 2009
Location: Golden, CO
Posts: 887
Likes: 0
Received 11 Likes
on
9 Posts
Car: 87 IROC
Engine: L31 350
Transmission: T56
Axle/Gears: 4.10 D44
Aluminum welder/fabricator in Denver
I am looking to get some welding done on my TPI runners. Does anyone have a recommendation for a welder in the Golden/Denver,CO area?
Thanks!
Thanks!
12-15-2014, 05:22 PM
#2
COTM Editor
iTrader: (11)
Join Date: Mar 2006
Location: WINDSOR, CO
Posts: 4,098
Likes: 0
Received 12 Likes
on
12 Posts
Car: 91 Z28, 87 SC, 90 IROC, 92 RS
Engine: LS1, 305 TPI, L98, NADA
Transmission: T56, 700r4's, and NADA
Axle/Gears: 3.89, 3.42, 3.23, NADA
Re: Aluminum welder/fabricator in Denver
Get ahold or Paul (Irocbirdbuilder) Govedik. He runs a small business out of his garage. Here is a link to his Facebook page.
https://www.facebook.com/Govsfabshop?ref=br_tf
I can get you his cell phone number if you wanna PM me
12-15-2014, 05:39 PM
#3
03-31-2015, 04:09 PM
#4
COTM Editor
iTrader: (11)
Join Date: Mar 2006
Location: WINDSOR, CO
Posts: 4,098
Likes: 0
Received 12 Likes
on
12 Posts
Car: 91 Z28, 87 SC, 90 IROC, 92 RS
Engine: LS1, 305 TPI, L98, NADA
Transmission: T56, 700r4's, and NADA
Axle/Gears: 3.89, 3.42, 3.23, NADA
Re: Aluminum welder/fabricator in Denver
Just wanted to pop in and say your intake is looking awesome man!
03-31-2015, 08:00 PM
#5
Senior Member
Thread Starter
iTrader: (5)
Join Date: Jan 2009
Location: Golden, CO
Posts: 887
Likes: 0
Received 11 Likes
on
9 Posts
Car: 87 IROC
Engine: L31 350
Transmission: T56
Axle/Gears: 4.10 D44
Re: Aluminum welder/fabricator in Denver
Thanks, Brandon! I forgot Paul was posting / didn't realize he was posting more pics on his facebook page.
Don't miss this one. I had to cut the runners 2/3s open to be able to port top to bottom. I extended the end mount so I could smooth that dip all the way out. That replaced 80mm bolts with 100mm.
Cut wide open!
Or the facebook page, if the photo didn't come across.
Just the top 1/3 to put back on. And cut a few chunks to fill in the gaps.
Don't miss this one. I had to cut the runners 2/3s open to be able to port top to bottom. I extended the end mount so I could smooth that dip all the way out. That replaced 80mm bolts with 100mm.
Cut wide open!
Or the facebook page, if the photo didn't come across.
Just the top 1/3 to put back on. And cut a few chunks to fill in the gaps.
Thread
Thread Starter
Forum
Replies
Last Post