Let's see your drag set up.
#51
Supreme Member
Re: Let's see your drag set up.
Owned since 1993...
#52
Re: Let's see your drag set up.
#54
Member
iTrader: (1)
Join Date: Feb 2002
Location: Ohio
Posts: 110
Likes: 0
Received 1 Like
on
1 Post
Car: 1970 chevelle
Engine: Lq4 408
Transmission: th400
Axle/Gears: 3:73
Re: Let's see your drag set up.
The electric water pump has been changed to a meziere,the junk one on there was from ebay,dont fall for it
#62
Member
Re: Let's see your drag set up.
@lugnut
how do you like your carb set up on your 6.0? Doing the same on my 5.3 lm7. Are you using the msd box and if so how do you like that as well? Thanks.
how do you like your carb set up on your 6.0? Doing the same on my 5.3 lm7. Are you using the msd box and if so how do you like that as well? Thanks.
#64
Member
Re: Let's see your drag set up.
[QUOTE=billybob6110;5932760]
[/QUOTE
That is damn nice right here
That is damn nice right here
#67
Supreme Member
iTrader: (56)
Re: Let's see your drag set up.
every thing has been swapped out for something diff.. and lighter...even this shot shows parts fitted..then swapped out for something newer..(hrs old and out)...lol
lack of motivation..have not done anything to the car all winter...just more parts shopping..but then I ran out of part upgrades...
lack of motivation..have not done anything to the car all winter...just more parts shopping..but then I ran out of part upgrades...
Last edited by articwhiteZ; 04-01-2017 at 03:14 PM.
#69
Supreme Member
iTrader: (56)
Re: Let's see your drag set up.
wish I had your energy/Motivation matt..but that's the plan..this week was pulling the cast iron carrier case out to have it swapped over the a aluminum carrier case. to drop a few lbs..this is the 2nd locker and case...diff gear ratio..for tuning..and play 1/8 and 1/4 mile..
hope to get the front cleaned up (eng bay) into new paint and clear..then start the install..of all the new parts front to back..top to bottom.
all new billet yokes for both setups
hope to get the front cleaned up (eng bay) into new paint and clear..then start the install..of all the new parts front to back..top to bottom.
all new billet yokes for both setups
Last edited by articwhiteZ; 04-03-2017 at 10:48 PM.
#70
Junior Member
Join Date: Dec 2016
Location: Appleton, Wisconsin
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1984 Pontiac Firebird Trans Am
Engine: 350 SBC
Re: Let's see your drag set up.
What size wheels you got on the bird? Looking for that exact set up rims and tires. What did you buy?
Thread
Thread Starter
Forum
Replies
Last Post
Street Lethal
Power Adders
634
04-30-2019 12:14 PM
mustangdmurder
Engine/Drivetrain/Suspension Parts for Sale
2
08-21-2015 07:17 PM