Anyone try a fourthgen dash w/ 10 point roll cage? Im just wondering if anyone has attempted or pulled this off cleanly |
nobody? |
i know IHI is going to run a 10 point cage with his fourth gen dash. the bars will come out of the heater duct holes on either side. |
I plan to do it as well, 10 pt with a '00 Z28 dash in my IROC-Z. But gonna be a while before it happens ... |
Originally posted by xpndbl3 i know IHI is going to run a 10 point cage with his fourth gen dash. the bars will come out of the heater duct holes on either side. |
With my firebird dash there are notches where the factory duct work went up the A pillars, so there will be no need to cut the dash anywhere. Worst case scenario would be having to have the down bars tweaked a little so they go through the 4th gen dash in the right spot AND meet up at the floor pan where the door bar is welded. Just assume the cage is already welded in place, the dash will literally just slide right upto the firewall with no modifications assuming the bars are in the right location. Edit: I was gonna install the halo and down bars, but new plans are to find a new car for track only and do the cut it, gut it, run it treatment. |
Yup for mine I plan to cut it and fit it after the bars are welded in. But I wanna do something different than the 10 point cages I see most people go with. The ones I've seen have the front two bars come down before the dash. I want the two front bars to line up with the a-pillars and go all the way to the firewall, then bend down. Mainly because I'm tall and I need all the leg room I can get. So I'm probably going to be cutting the upper part of the dash so I can slide it in and secure it. |
Originally posted by CrazyHawaiian Yup for mine I plan to cut it and fit it after the bars are welded in. But I wanna do something different than the 10 point cages I see most people go with. The ones I've seen have the front two bars come down before the dash. I want the two front bars to line up with the a-pillars and go all the way to the firewall, then bend down. Mainly because I'm tall and I need all the leg room I can get. So I'm probably going to be cutting the upper part of the dash so I can slide it in and secure it. |
All times are GMT -5. The time now is 11:08 AM. |
© 2024 MH Sub I, LLC dba Internet Brands