Third Generation F-Body Message Boards

Third Generation F-Body Message Boards (https://www.thirdgen.org/forums/)
-   DFI and ECM (https://www.thirdgen.org/forums/dfi-ecm/)
-   -   Accel DFI Program Reload Question (https://www.thirdgen.org/forums/dfi-ecm/645461-accel-dfi-program-reload.html)

IROC_U 03-18-2012 05:17 PM
Accel DFI Program Reload Question
 
Hey guys, haven't been on here in a while, but I recently got my Accel DFI gen 7 computer back after sending it off to get it fixed. Now that I got it back, I'm trying to figure out how to reload my previous tune. Anyone on here have any idea how to go about doing this? Thanks!

efiguy 03-20-2012 07:13 PM
Re: Accel DFI Program Reload Question
 
Originally Posted by IROC_U (Post 5216110)
Hey guys, haven't been on here in a while, but I recently got my Accel DFI gen 7 computer back after sending it off to get it fixed. Now that I got it back, I'm trying to figure out how to reload my previous tune. Anyone on here have any idea how to go about doing this? Thanks!
If you sent it to Accel your tune should still be in there but if not, then boot up, go to C drive on your computor, then Gen 7 Calmap, then to Global calibrations. Pick your cal out of the file, then press F7, it'll load it from there.

I'm an Accel EMIC, send me a copy and your build specs, I'll help if you like.
fastone01@hotmail.com

Mark


All times are GMT -5. The time now is 09:20 PM.


© 2024 MH Sub I, LLC dba Internet Brands