Identification of Harness End
 

Hello, I just finished my quicksilver install, getting all of my wires cleaned up in the car after swapping everything from the 88 to the 85 so that I can go register it and need help identifying this one harness plug end. I took a picture of the end that slides or plugs into something and a picture showing the colors of the wires. They are Orange, White, Off-White/Tan, and Black. Wires are approx 14-12 ga. wire.

Thanks ahead of time!!! :)

Attachment 427882

Attachment 427883

Re: Identification of Harness End
 

If it helps, the plug end says "PACK-CONN" on it.

Re: Identification of Harness End
 

Where is this located?

Do your turn signals work?

Re: Identification of Harness End
 

I can't get out to the shop right now but will drive out there first thing in the morning to double check the turn signals, pretty sure they work. This harness connection is on the driver side, under dash, right next to the power distribution block the different wires plug into.

Re: Identification of Harness End
 

I 'think' Ive seen this same plug on my car, and it plugs into another connector hanging off of a wire, but the connector looks totally different than what you would expect, its hard to explain, just look for another missing connection.

Re: Identification of Harness End
 

bradley2150, I looked for a connection, I do not see one under there, and no, for some reason my turn signals are not working but my emergency flashers do.

Re: Identification of Harness End
 

that looks like aftermarket.
gm uses a propriatary plug/s and when i have to hack into them i cant just get the same plug to fit, i have to make up a harness connection.

Re: Identification of Harness End
 

If I get a chance, Ill see if I can snap a pic of what I am talkin about.

Re: Identification of Harness End
 

i appreciate the reply's guys, I really do. I took it out for a full test run tonight with insurance and registration on it, first time in 7 years, it was unbelievable, you know like that first time driving a camaro. I had an adrenaline rush and was shaking just a bit. I really like the Transgo full-manual kit w/ quicksilver shifter, exhaust through the powerstick. Just need to get all the bugs worked out now :burnout:

Re: Identification of Harness End
 

Ok, grabbed the camera and took some hi def pics so that it is clearer as to what I am talking about, could also use some help with a couple other wires. This car has no stereo, no AC, no Heat, no smog, just the lights, gauges, MAF, engine sensors and ECM. Car must have VATs bypassed because the old columns ignition would start car without a key in it, so I kept the column from an '85 and its key which has no chip and the '88s ECM doesnt fuss at all, car starts right up.
Attachment 427272

Attachment 427273

Attachment 427274

What are these wires for?

Attachment 427275


Attachment 427276