LSx swap harness Hi all, I have a swap harness that was built by member Pocket for me back in 2014. Never took it out of the box. Here are the specs he built it for: Year of 3rd gen: 1991 RS Original trans type: T5 Original EFI car? Original TBI car, changed to carb'd ZZ4. I'll be running a single Walbro 400 LPH pump in the stock third gen tank for now. Year of PCM being used: Planning on 99-02 PCM location: Stock 3rd gen PCM routing: Hidden under HVAC box and mounted under the dash Trans type: 4L60E Block type: GEN III Intake: LS6 Throttle Body: Drive by cable Injector style: EV1 MAF type: Probably not going to run MAF, but if you could pin for Fbody 3 wire just in case that'd be good MAF location: Stock Fbody near TB AC: 4th gen low mount Emissions: Delete Rear O2s: Delete Coolant gauge: Use 98 Fbody CTS in driver cyl head Alt: Fbody 1 wire Alt Location: Stock Fbody Number of fans: Dual (4th gen setup) Battery location: Drivers side Relay center location: Stock near booster Note, back up lights run through the engine harness Obviously, this could be modified as needed by the buyer to fit the application. $500 shipped. Let me know if you have any questions! |
Re: LSx swap harness Payment sent. This should work perfect for my 91 LSX swap with a few minor changes. Thanks! |
All times are GMT -5. The time now is 06:18 PM. |
© 2024 MH Sub I, LLC dba Internet Brands