Old style, stock GM valve covers
 

Anyone got a nice (not rusty) set of old style GM valve covers, parimiter bolt?

I don't want any chrome tinfoil mr gasket covers. Just the stock ones, like in the picture below:

http://members.cisdi.com/~anesthes/s...1/almost/1.JPG

My special, fancy, expensive aftermarket covers are a little too tall and whack my turbo.

-- Joe

Re: Old style, stock GM valve covers
 

85-86 TPI only style..... I've got a couple pair.

Not sure of thier condition but I'll check into it; Should still have at least 1 set that was blasted and re-painted as well as some factory original used covers ( with some rust pitting )

Let me know if restored parts or original used condition parts ( minor defect or 2 ) are best for you. Feel free to make an offer and be sure to include your ZIP code for a shipping quote.

:driving:

Re: Old style, stock GM valve covers
 

I don't even know where to begin.

If you wanna just PM me condition and your asking price for either set shipped to 03079, we can go from there.

-- Joe

Re: Old style, stock GM valve covers
 

I'll get into the garage tomorrow and will pull them out so I can take some pics. Once I know more I'll send you an update with what i find.

:driving:

Re: Old style, stock GM valve covers
 

A couple others have asked about these covers after I posted here; Joe gets first pick......



Here are the pics:


Set 1 : Typical used $35 + shipping, didn't notice and dings, several rusty spots,........

http://berlinetta.info/temp/ValveCoversTPI1a.jpg

http://berlinetta.info/temp/ValveCoversTPI1b.jpg

http://berlinetta.info/temp/ValveCoversTPI1c.jpg


Blasted / re-painted, $55 + shipipng. A very small ding on bottom near corner of the valve cover to the left in the pics, ( drivers side top rear when mounted )and there's a few marks on them from being handled too. They could use a quick clean-up and re-spray before installing them to look thier very best.
http://berlinetta.info/temp/ValveCoversTPI2a.jpg

http://berlinetta.info/temp/ValveCoversTPI2b.jpg

http://berlinetta.info/temp/ValveCoversTPI2c.jpg


Blasted / re-painted $75 + shipping: Very good used condition.

http://berlinetta.info/temp/ValveCoversTPI3a.jpg

http://berlinetta.info/temp/ValveCoversTPI3b.jpg

http://berlinetta.info/temp/ValveCoversTPI3c.jpg


I didn't get shipping quotes for anyone yet but will get them ASAP once I know that someone is seriously interested.

:driving:

Re: Old style, stock GM valve covers
 

John,

I'll take the $55 ones. Can you give me a total with shipping to 03079 and your paypal info? I'd like to get this transaction done asap.

-- Joe

Re: Old style, stock GM valve covers
 

The only set remaining is set 3,... Very good condition.

:driving:

Re: Old style, stock GM valve covers
 

I also have a set. I replaced them with a chrome set. One has a slight problem though. Looks like somebody was cutting the air tubes off the ex manifolds with a grinder and cut a small slit in the driver cover at the back. I never even knew until I took them off. The slit was filled with silicone and never leaked. If your interested in them you can just have them, you pay shipping of course.