TPI to Carb, What Distributor I am pulling the motor out of my 90 Camaro Iroc, 350 TPI, and putting it into my 79 El Camino. I am going to remove the TPI system and put on a 2104 Edelbrock Intake and 1406 Edelbrock Carburetor. Leaving the rest of the motor alone. My question is what distributor do i need to use? |
Do you have the '79 distributor? If so, it will be fine. If not, something like it. |
Re: TPI to Carb, What Distributor would he need a bronze (or melonized) distributor gear with that? |
Re: TPI to Carb, What Distributor Not with a stock cam |
Re: TPI to Carb, What Distributor according to Sallee-Chevrolet: "2) All Roller camshafts are either Hardened Iron core or Steel camshafts which require a hardened distributor gear." Wouldn't that include the cam from a stock 1990 l98? |
Not bronze. Melonized. I don't recall if the small-cap distributors used the same shaft size, but if they did, the gear off of the later distributor would be fine on an earlier large-cap. Or, you can get the melonized gear from GM. |
Re: TPI to Carb, What Distributor Would it be easier instead of trying to buy a new gear, just taking the stock distributor out and taking the gear off of it, then buying an Accel 59107 GM Hei Distributor and putting the stock gear onto that? |
If the shafts are the same diameter, you can do that. But, I don't know whether or not they are. |
All times are GMT -5. The time now is 04:07 AM. |
© 2024 MH Sub I, LLC dba Internet Brands