Third Generation F-Body Message Boards

Third Generation F-Body Message Boards (https://www.thirdgen.org/forums/)
-   Engine Swap (https://www.thirdgen.org/forums/engine-swap/)
-   -   350 tbi swap into 89 Firebird (https://www.thirdgen.org/forums/engine-swap/723281-350-tbi-swap-into.html)

xkingcodex 08-14-2015 01:28 AM

350 tbi swap into 89 Firebird
 
Hello. I have a 350 tbi engine out of a 95 chevy silverado. It looks like it should mount right up but I was wondering for any advice about anything I might need to swap over also. I have the silverado so I can take any parts I need to from it. The car the engine is going into is a 89 Firebird Formula that had a 305 tbi until heads cracked. Thank you in advance.

fireburdluvr85 08-14-2015 08:09 AM

Direct drop in, need to have a 350 chip tho. The 95 pcm isn't the same unless you swap the harness and pcm. Other slight differences

fireburdluvr85 08-14-2015 07:46 PM

I figured he has the whole motor. Lol

xkingcodex 08-14-2015 07:49 PM

Re: 350 tbi swap into 89 Firebird
 
Yeh, I have everything. Just didn't know if factory computer would hook up

fireburdluvr85 08-14-2015 08:07 PM

No. Some guys were swapping the pcms into our cars in the past but I've been out of the TBI game awhile

xkingcodex 02-08-2016 10:12 PM

Re: 350 tbi swap into 89 Firebird
 
So I swapped the engine out with the 350. I used the 305 harness and pcm. Then I used everything connected to the engine (intake, sensors) and put it in. The only thing I found is that I used the 305 tranny and it didn't take the extra power. And I found that the Alternator mount actually sat higher relative to the engine so if I stepped on it hard, the Alternator would vibrate against the hood. Since the tranny went, I went forward and bought a parts car to throw a t5 transmission into it. Now I can spin tires up through the first 3 gears. During a dry day!!! Very excited. Should anyone have any questions after I post this reply, feel free to pm me. Thanks everyone who helped and sent me a reply.

Biggd4355 02-18-2016 02:49 PM

Re: 350 tbi swap into 89 Firebird
 

Originally Posted by xkingcodex (Post 5950915)
Hello. I have a 350 tbi engine out of a 95 chevy silverado. It looks like it should mount right up but I was wondering for any advice about anything I might need to swap over also. I have the silverado so I can take any parts I need to from it. The car the engine is going into is a 89 Firebird Formula that had a 305 tbi until heads cracked. Thank you in advance.

the swap should be easy, they are the same block and tranny. The o2 sensor should still operate the same, the injectors should work fine too. They are all 12 volt activated by a grounding signal. I do however recommend upgrading the exaust

grover85 02-18-2016 09:28 PM

Re: 350 tbi swap into 89 Firebird
 
So why do you need to swap spark control module if you get a custom chip?

Biggd4355 02-18-2016 09:49 PM

Re: 350 tbi swap into 89 Firebird
 
a chip will change your timing, advances it, which makes the engine run a bit warmer so they tell you to put in a cooler thermostat. You can also advance the timing with the engine not running, it will stay advanced. Your car shuts down at 110 mph, it's not recommended, but you can run a switched wire to the fuel pump relay, it won't shut down at 110. So what is your question about the chip?

grover85 02-18-2016 09:57 PM

Re: 350 tbi swap into 89 Firebird
 

Originally Posted by Biggd4355 (Post 6007900)
a chip will change your timing, advances it, which makes the engine run a bit warmer so they tell you to put in a cooler thermostat. You can also advance the timing with the engine not running, it will stay advanced. Your car shuts down at 110 mph, it's not recommended, but you can run a switched wire to the fuel pump relay, it won't shut down at 110. So what is your question about the chip?

Not sure if your replying to my post but non of this makes sense

Blizzard Bill 02-19-2016 09:28 AM

Re: 350 tbi swap into 89 Firebird
 

Originally Posted by xkingcodex (Post 6004611)
So I swapped the engine out with the 350. I used the 305 harness and pcm. Then I used everything connected to the engine (intake, sensors) and put it in. The only thing I found is that I used the 305 tranny and it didn't take the extra power. And I found that the Alternator mount actually sat higher relative to the engine so if I stepped on it hard, the Alternator would vibrate against the hood. Since the tranny went, I went forward and bought a parts car to throw a t5 transmission into it. Now I can spin tires up through the first 3 gears. During a dry day!!! Very excited. Should anyone have any questions after I post this reply, feel free to pm me. Thanks everyone who helped and sent me a reply.

Come on now, the 305 tranny couldn't take the power???

Blizzard Bill 02-19-2016 09:30 AM

Re: 350 tbi swap into 89 Firebird
 
That must be a hellofa truck engine!!!

HEFF16 02-19-2016 03:01 PM

Re: 350 tbi swap into 89 Firebird
 
I'm swapping a 88 305 TBI out for 88-89 350 TBI in an 88 IROC. So ECM is to be changed or can u get 305 upgraded? (chipped). What else to make this transition easy. I've read knock sensor. Any help would be appreciated.

xkingcodex 03-10-2016 10:33 PM

Re: 350 tbi swap into 89 Firebird
 

Originally Posted by HEFF16 (Post 6008095)
I'm swapping a 88 305 TBI out for 88-89 350 TBI in an 88 IROC. So ECM is to be changed or can u get 305 upgraded? (chipped). What else to make this transition easy. I've read knock sensor. Any help would be appreciated.

Sorry, you probably got all your info but figured I'd reply. Ive read you can change the ecm or get it chipped but I'm running a good a/f ratio with my stock ecm. As long as you make sure to use the intake from the 350 so it has the bigger tbi and injectors.

Darren L. Rich 02-12-2020 07:43 PM

Re: 350 tbi swap into 89 Firebird
 
Solid motor mounts- or a chain to the frame on the driver side to hold it from moving! Poly mounts might keep it from hitting too.


All times are GMT -5. The time now is 09:00 AM.


© 2024 MH Sub I, LLC dba Internet Brands