Exhaust and subframe connectors
 

Hi
How are you doing to make room for the exhaust when you have subframe connectors Installed?
Have a 1989 TTA

Re: Exhaust and subframe connectors
 

I have the UMI subframe connectors
http://umiperformance.com/catalog/in...roducts_id=127

No problems with the catback. The Y pipe was fine when I use 2." inch piping but when I went to 3" I had to cut and angle it a bit down by the brace to get it to fit.

Re: Exhaust and subframe connectors
 

The Spohn connectors give factory-like clearance to the y-pipe, which is where 90% of the problem is with subframes.

Re: Exhaust and subframe connectors
 

:yup:


I run Spohn subframe connectors with 3" factory style exhaust, Hooker 2055 headers and y-pipe. Everything fits perfectly.

Re: Exhaust and subframe connectors
 

Ok
I have the Competition Engineering#247-3111
Subframe Connectors
1982-92
And its written that they dont fit facory exhaust😫
Think i just have to start to cut into the subframe
Didn t notice that when i bougth them.

Re: Exhaust and subframe connectors
 

Honestly, I would sell those and buy Spohn or UMI or BMR subframe connectors. All of which fit stock exhaust and no cutting the subframe is required.

Re: Exhaust and subframe connectors
 

Well thats not going to happend,i dont think you cant buy those in sweden and shipping is very expensive.
I going to modify the one i have on the car and hope they still do some good,car make close to 600fwhp so think i need them

Re: Exhaust and subframe connectors
 

I undererstand. I just would hesitate before cutting ANY of the subframe on your car. Congrats on 600whp though, that's impressive! And yes, that does demand you install some kind of sub frame connectors. :)

Re: Exhaust and subframe connectors
 

I vill not cut on subframe just going to flat out a pice of 4 inch on the connectors,they are already bolted to the car and fits fine exept for exhaust clerence