New turbo header photos w/ion
 

I will have the entire cold piping tacked and hopefully partially finish welded this weekend.

This is the finished passenger and drivers side headers. The crossover is finished as well but is not painted yet. hehe

Anyway, here you go. I should be back at the end of the weekend with some pretty close to finished shots of this setup.

http://www.hustonstreetracing.com/fab/lutes/31.JPG
http://www.hustonstreetracing.com/fab/lutes/32.JPG
http://www.hustonstreetracing.com/fab/lutes/33.JPG
http://www.hustonstreetracing.com/fab/lutes/34.JPG

Guido looking awesome....

Cant wait to see some done Pic's..

outstanding work!

ok now make a jig :)

Ran into a couple of small issues over the weekend that slowed me up, but I got the wastegate plumbed tonight

http://www.hustonstreetracing.com/fab/lutes/35.JPG
http://www.hustonstreetracing.com/fab/lutes/36.JPG
http://www.hustonstreetracing.com/fab/lutes/37.JPG
http://www.hustonstreetracing.com/fab/lutes/38.JPG

Damm thats all a tight fit. what about motor movement? any room for it with how close that looks to the rad. and Alt??

I haven't been in this board for awhile, but i take it you are building turbo headers for people?

Guido,
Lookin' good! Are those V-band clamps you're using? I've been looking to find an inexpensive supplier, and not having much luck... :P

Andris

Yea, same here... but I've also found out that there are at least 2 difernt types of v-band clamps/flanges and haven't figured out how to tell them appart, just that they don't mix and match well.