ECM Programs wanted I am looking for the Stock running (memcal) PROGRAM for a 80s 350 with TPI with MAF and for a 93 Chevy van running a 16168625/16186695 ECM. The ones you can load into a laptop and run the van from IT and then using TunerPro adjust on the fly. The van is needed now to try and improve both its MPG (10/14) and performance if possible. I hope to switch the 93 Chevy Van from TBI to TPI this winter, which I have two set ups with MAFs, one from a Camaro and the other from a Corvette. These are in storage so cannot get their ECM numbers. And or: Any local Phoenix shop doing these older OBDI systems, and can burn a new chip?? Or any program running the Lean Burn Cruse settings or how to turn them on?? Thanks. Rich Farther information to clear up some misunderstandings: I am trying to do this in stages…first stage as I am CURRENLY running the Stock 93 Chevy Van 5.7 350 computer driving a TBI system, I was trying to improve ITS MPG until we get into cooler temps like out winter this Halloween, then I am considering a TPI with either the original PCM or a 95 LS PCM with its tranny control and better one at a time injector system..and yes I know about opt-spark. Later I plan on getting a 6L80E transmission (Or a 8L90E IF it can be used...)with a control computer for it and a rebuilt rear end with possi and a TALL 2.20:1 gear ratio. Rich |
Re: ECM Programs wanted Here is a memcal for your 625 ecm , sounds like your looking for a memcal for a 1227165 ecm ? 6e mask has hwy mode but also have vats that needs to be programmed out. I have a few options if you send me a pm and I can do reprogramming. https://m.ebay.com/itm/16168625-BDJY...pe!90011!US!-1 |
Re: ECM Programs wanted Or the newer 8 Speed 8l90e: 6L80E Gear ratios: 1St: 4.484 2nd 2.872 3rd. 1.842 4Th. 1.141 5th. 1.00 6th. 0742 8L90e Gear Ratios… 1st. 4.56 2nd. 2.97 3rd. 208 4th. 1.69 5th. 1.27 6th. 1.00 7th. 0.85 8th.0.65 |
Re: ECM Programs wanted Damn it I hate how this system takes out all spacing and formating,....I had very nice layout for those numbers...as a run on sentence it is a mess. Rich |
Re: ECM Programs wanted For the oem ecm you should look at pro thread https://www.thirdgen.org/forums/tpi/...p-305-tbi.html As far as hwy mode for the factory ecm you should ask tunercat to see if it can be enabled. Or piggyback the factory ecm with a 165 ecm. The ecm needs a vss signal a Dakota digital sgi-5 might be the answer for that. |
Re: ECM Programs wanted
Originally Posted by racprops
(Post 6235319)
Damn it I hate how this system takes out all spacing and formating,....I had very nice layout for those numbers...as a run on sentence it is a mess. Rich "The [code] tag switches to a fixed-width (monospace) font and preserves all spacing" So you can input [ code ]4L60-E[ /code ] without the spaces and it will display 4L60E without goofing it up. |
All times are GMT -5. The time now is 01:21 AM. |
© 2024 MH Sub I, LLC dba Internet Brands