Tie rod end threads I want to make some solid adjusters for the tie rods. Does anyone know the thread on the end of the tie rods? Thanks for any help. |
Re: Tie rod end threads 5/8-18 |
Re: Tie rod end threads
Originally Posted by //<86TA>\\
(Post 6269276)
5/8-18 One end left handed and one right handed correct? |
Re: Tie rod end threads Correct |
Re: Tie rod end threads Make sure you have plenty of thread engagement on both sides. The replacement moog tie rods seem to be longer than OEM which can prevent you from adjusting them where you need them. Or, trim off a bit off each end rod. |
Re: Tie rod end threads I was thinking of measuring the stock adjuster and using that length. |
Re: Tie rod end threads Do you think 1" 6061-T6 hex stock would be strong enough for this part? |
Re: Tie rod end threads IMHO, for street use steel would be better. If it is a drag only car then aluminum is fine. Also, unless you have the taps and such, it may be cheaper to just purchase a set from a place such as Coleman racing. RBob. |
All times are GMT -5. The time now is 04:01 AM. |
© 2024 MH Sub I, LLC dba Internet Brands