Third Generation F-Body Message Boards

Third Generation F-Body Message Boards (https://www.thirdgen.org/forums/)
-   TPI (https://www.thirdgen.org/forums/tpi/)
-   -   Part Number Needed (https://www.thirdgen.org/forums/tpi/165371-part-number-needed.html)

DJP87Z28 03-07-2003 10:54 AM

Part Number Needed
 
I am looking for a P/N for the Four Prong Plug with attached wire for the IAC valve (Idle Air Control) used on 87 305/350TPI or other years. Is this Item available???/

Blown87 03-07-2003 11:47 AM

The connector can be purchased through Year One. The part number is WP99 and costs $3.95. Their web address is www.yearone.com. You can order it there.

91Z28-350 03-07-2003 11:54 AM

That's the wrong part. The IAC is a 4 prong, but in a square configuration (2x2). WP64 looks to be right. I can't say if it is though. There are slots on the poles, which need to match up.

DJP87Z28 03-07-2003 12:29 PM

Thanks, I will check year one out and it is the square 4 prong.

Blown87 03-07-2003 01:51 PM

Sorry. I just checked, and the part number WP99 is for an idle control solenoid. I believe the part number for the IAC motor is in fact WP64. But again, check to be sure it is what you are looking for.

DJP87Z28 03-07-2003 02:29 PM

Blown87
I checked the yearone site and the W64 looks like what I need.
Ordered one for $10.30 but their shipping charges by UPS are out of this world. But I will pay them.:rolleyes:

DJP87Z28 03-18-2003 10:42 AM

I got that Plug from Yearone and it was what I needed. $10.30
+S/H was not bad considing the Dealer wanted $94.03 for the same Plug with 6" of wire attached. GMPARTDIRECt was $56.03. Just reinstalled it with the old wire connecters.:) :)


All times are GMT -5. The time now is 02:56 PM.


© 2024 MH Sub I, LLC dba Internet Brands