Shift issue when you manually shift 700R4 When you place the shifter in overdrive, come to a complete stop and floor it, the car shifts at 4800 rpm, works like it should. When you place the shifter in 1st and floor it, you can shift in to second just fine, when you try to shift into third, nothing happens it stays in 2nd, even if you shift into overdrive, the only way it shifts if you let off the throttle. I just did a filter and fluid change, replaced the govenor as well. Adjusted TV cable per procedure Any ideas on the cause/reason |
Re: Shift issue when you manually shift 700R4 I talked to Dana at Probuilt about this same issue earlier today and he said that it is the 3-4 clutch pak that it going bad. |
Re: Shift issue when you manually shift 700R4 It makes the 2-3 shift at 4800 with the shifter in OD? That's interesting because alot of people, myself included, have trouble getting the 700R4 to make a WOT 2-3 shift, regardless of the shifter position. Mine will FINALLY shift, up at about 6200rpm. ATTENTION: Dana at ProBuilt- Why doesn't the 700R4 want to make a WOT 2-3 shift at a "normal" shift point.....I've got the heaviest weights and the lightest springs from the B&M shift point (governor modification) kit installed. It does finally shift, but only when you're so frustrated you just keep the throttle pinned and say,"It shifts, or it comes apart!" Other than that, I love my ProBuilt 700R4.:) -Bill P.S: the above post came up while I was typing my post. My trans has a new 3-4 clutch pack (ProBuilt street/strip rebuild kit). Dana???? |
Re: Shift issue when you manually shift 700R4 Call me? 909 7951876. Dana |
Re: Shift issue when you manually shift 700R4
Originally Posted by Pro Built Automatics
(Post 3778335)
Call me? 909 7951876. Dana Dana, I did put the car in 1st and then manually shifted into second, then contunied right to OD and the transmission shifted fine. I then held it in second and then shifted to third and it was fine. Thanks for the help! |
Re: Shift issue when you manually shift 700R4 Dana, I'll give you a call. -Bill |
Re: Shift issue when you manually shift 700R4 Now scribe a "new" full mark on your dipstick. |
Re: Shift issue when you manually shift 700R4
Originally Posted by Pro Built Automatics
(Post 3778847)
Now scribe a "new" full mark on your dipstick. |
Re: Shift issue when you manually shift 700R4 If you let off the throttle just a little it will shift? |
Re: Shift issue when you manually shift 700R4 Time to replace! |
All times are GMT -5. The time now is 04:04 AM. |
© 2024 MH Sub I, LLC dba Internet Brands