Third Generation F-Body Message Boards - Search Results

 
Search: Posts Made By: Twin_Turbo
Showing results 1 to 50 of 498
Search took 0.23 seconds.
Forum: Car Audio
11-05-2018, 05:09 AM
Replies: 26
Views: 7,147
Posted By Twin_Turbo

Re: RM610E Cockpit Radio install

I don't have them anymore.
Forum: TBI
10-24-2018, 06:47 AM
Replies: 7
Views: 149
Posted By Twin_Turbo

Re: "84 Xfire Stalling - Which CTS Feeds WUD Reading?

The one under the thermostat. If its the mushroom type replace it for a tpi weatherpack type w pigtail. The mushroom type are motorious for corroded connection resulting in rich running.
10-24-2018, 05:56 AM
10-09-2018, 11:00 AM
Replies: 386
Views: 28,077
Posted By Twin_Turbo

Re: T-RAM OWNERS

Messages dont work on my IB app. I have no idea of value. 2k wont buy mine. ...I do know that.
10-05-2018, 03:04 PM
Replies: 386
Views: 28,077
Posted By Twin_Turbo

Re: T-RAM OWNERS

How much is top $? I have one
Forum: Exhaust
09-27-2018, 02:46 AM
Replies: 58
Views: 1,939
Posted By Twin_Turbo

Re: need help choosing an exhaust

Spintech....

https://youtu.be/6_r7IeO77DU

https://youtu.be/jSRg4HXcyb8
09-20-2018, 04:59 AM
Replies: 406
Views: 78,138
Posted By Twin_Turbo

Re: 1982 Trans Am, it needs some lovin too

https://youtu.be/6_r7IeO77DU

It runs strong 😁
09-20-2018, 04:26 AM
Replies: 5
Views: 206
Posted By Twin_Turbo

Re: 86 Camaro steering shaft upgrade

How much shipped to the netherlands
09-19-2018, 01:17 PM
Replies: 261
Views: 16,433
Posted By Twin_Turbo

Re: Jeep cherokee and Astro van steering shafts

I am looking for a shaft preferrably with the rubber isolator.
09-19-2018, 01:16 PM
Replies: 5
Views: 206
Posted By Twin_Turbo

Re: 86 Camaro steering shaft upgrade

I need one WITH the rubber insulator preferred
Forum: TPI
08-27-2018, 06:01 AM
Replies: 23
Views: 778
Posted By Twin_Turbo

Re: Who has used the C4 gear reduction starter?

Using nothing else on most of my cars. They are rugged starters
07-21-2018, 11:29 AM
Replies: 6
Views: 251
Posted By Twin_Turbo

Re: Speedometer for T56

You calculate pulses per rev to ppm depending on axle ratio and tire size. Tgen figure out what you need to get a 4k ppm signal. I have used the stock buffer box to get down from a converted 8k...
Forum: Power Adders
06-12-2018, 05:23 PM
Replies: 4
Views: 280
Posted By Twin_Turbo

Re: Procharger Crank Pulley

Space out the SC bracket.
Forum: Power Adders
06-11-2018, 02:26 AM
Replies: 4
Views: 280
Posted By Twin_Turbo

Re: Procharger Crank Pulley

The pulley that comes with it should be a pulley and spacer. I have machined tge spacer for perfect alignment. It was off out of the box but probably tolerance stacking (and damper thickness)
05-31-2018, 06:41 AM
Replies: 5
Views: 167
Posted By Twin_Turbo

Re: Need help identifyiing connector on 1987 IROC

It goes to the egr solenoid originally bolted on the pass side intake manifold bolt next to the coil
05-31-2018, 03:07 AM
Replies: 18
Views: 559
Posted By Twin_Turbo

Re: What differences are there in flat tappet lifters?

No hardened foot lifters were factory in a lot of pre 87 engines. Even pretty lame ones (l82 l83) I always keep thosr and if not worn concave I refinish tge foot and keep the ones that are the best...
05-30-2018, 09:59 AM
Forum: Electronics
05-28-2018, 02:46 PM
Replies: 5
Views: 177
Posted By Twin_Turbo

Re: Unplugged wire

Yup back of ac compressor
05-27-2018, 04:18 AM
05-26-2018, 02:57 AM
Replies: 61
Views: 1,622
Posted By Twin_Turbo

Re: T-5 swap gone bad

And as you can see both are counterweighted
05-25-2018, 08:03 AM
Replies: 14
Views: 1,144
Posted By Twin_Turbo

Re: BLACK INTERIOR FOR SALE

82 does not have the lowet retractor. Sills are different on those also. Later stuff does bolt on.
Forum: LTX and LSX
05-25-2018, 04:56 AM
Replies: 7
Views: 334
Posted By Twin_Turbo

Re: LS1 swap high fuel pressure 100psi

The filter regulator in and return ports are illogically placed....
The outer one on the 2 port side is the inlet. The center one the return
05-25-2018, 01:32 AM
Replies: 61
Views: 1,622
Posted By Twin_Turbo

Re: T-5 swap gone bad

Yes and see that large raised portion on the right side from 2 o clock to 4? That's the heavy side. That is not a neutral fw. The N after casting nr means nodular.
05-24-2018, 02:48 PM
Replies: 61
Views: 1,622
Posted By Twin_Turbo

Re: T-5 swap gone bad

A 1pc rms engine is combo balance. Internal on the front and the loss of the D shaped balance pad on tge rear flange is in the flywheel or flexplate. Neutral flywheel/flexplates are for internally...
05-07-2018, 03:05 PM
Forum: Brakes
05-07-2018, 03:04 PM
Replies: 17
Views: 1,367
Posted By Twin_Turbo

Re: Zr1 brake kit

I have the c6z06 stuff in 1 if my gen 3s and my gen4. I prefer the 3 without the abs. They are easy to modulate especially with the 1pc pads and aftermarket rotors (oems are directional canes but...
Forum: Electronics
04-22-2018, 08:32 AM
Replies: 18
Views: 501
Posted By Twin_Turbo

Re: Green wire coming out behind engine near heater box...?

Oh pic didnt load on app for me. Its light green. I dont think v6s have an ac throttle kicker. Must be from a thermostatic vac valve or sensor. Does it go into the loom under the ac box that...
Forum: Electronics
04-22-2018, 05:46 AM
Replies: 18
Views: 501
Posted By Twin_Turbo

Re: Green wire coming out behind engine near heater box...?

3 possibikities

Fan switch pass rear head
Ac clutch
Ac on fan control (fan on with ac control on)
04-22-2018, 05:41 AM
Replies: 17
Views: 711
Posted By Twin_Turbo

Re: Astro shaft

Artic that gold one has my name on it :D. I need it lol. All my hardware is zinc plated

https://photos.app.goo.gl/Wr7QTLAYN3mKUUtg1
Forum: Electronics
04-20-2018, 03:23 AM
Replies: 12
Views: 946
Posted By Twin_Turbo

Re: wiring a 82 wiper motor to run off 91 electronics

Yup. Firewall mod required


https://photos.app.goo.gl/w2mzaFjmaD4bo17x2

That is jproz's old car after I cleaned up the mod
04-09-2018, 03:50 PM
Replies: 20
Views: 929
Posted By Twin_Turbo

Re: Reasonably priced T56 setup

Hope you have the slave cylinder spacer with it
04-08-2018, 04:03 AM
Replies: 16
Views: 1,041
Posted By Twin_Turbo

Re: Hawks custom mini ram

Must be me but I think it has potential.
Forum: Brakes
04-04-2018, 02:45 AM
Replies: 6
Views: 584
Posted By Twin_Turbo

Re: 13" baer front disc kit

Solution for shock length....


https://photos.app.goo.gl/tsdZjfByS5umcWDx1

Look at the lower shock mount
Forum: Body
03-26-2018, 02:13 AM
Replies: 46
Views: 1,176
Posted By Twin_Turbo

Re: gasoline odors in garage.

Fix what you have. Ive done it a couple of times. Brazing the neck is easy. Fitment guaranteed
Forum: Body
03-25-2018, 08:27 AM
Replies: 46
Views: 1,176
Posted By Twin_Turbo

Re: gasoline odors in garage.

Man fragrance ... nothing wrong wuth that. Fuel and wd40. The cologne of choice
03-23-2018, 11:12 AM
Replies: 8
Views: 599
Posted By Twin_Turbo

Re: Wideband o2 Sensor install

Yes the simulated nb output. Most kits have that
Forum: Brakes
03-21-2018, 05:27 PM
Replies: 32
Views: 816
Posted By Twin_Turbo

Re: Do you have to bench bleed the master?

That's why I said... crack the bleeders and use a vac can in the 4 corners to pull fluid in and only start pumping the oedal for that last bit if firmness.
03-20-2018, 10:16 AM
Replies: 406
Views: 78,138
Posted By Twin_Turbo

Re: 1982 Trans Am, it needs some lovin too

https://lh3.googleusercontent.com/oE3jx9EPLRt9v2WmHScM5qOvfLMpxd_wW4dpsgOaGAN1zZocSqYozT3DzmrECYZa6iDWvh5kFbCfP3FTEB1DpWEKmw4dkJj4aD-KgM224jFrA5bv3b6stlrDdn3nyImyyPCNlIiS96a9UWqfMoXzkgqQNFUubdcWninLho...
03-20-2018, 10:09 AM
Replies: 406
Views: 78,138
Posted By Twin_Turbo

Re: 1982 Trans Am, it needs some lovin too

I'm not running boosted, just carbed. I do have a buddy for whom i built a supercharged C5 and he runs the stock radiator without issues. the weather however is a lot colder here.
03-20-2018, 07:33 AM
Replies: 406
Views: 78,138
Posted By Twin_Turbo

Re: 1982 Trans Am, it needs some lovin too

fabbed new fuel lines that run through the SFC for protection and with armoring around where it's exposed. uses a bulkhead on both sides to hook to soft lines
...
03-19-2018, 02:42 AM
Replies: 8
Views: 599
Posted By Twin_Turbo

Re: Wideband o2 Sensor install

None of the aftermarket come wired or instructed like I said. Now wonder why oem wbo2s are good for 100.000 miles and these aftermarkets crap out a lot using the exact same sensors. It's the...
03-18-2018, 09:07 AM
Replies: 8
Views: 599
Posted By Twin_Turbo

Re: Wideband o2 Sensor install

No.... buy a gauge with sensor. Install the gauge and wire the sensor heater via a time relay or an egt switch. Might even use tge oem switching valve wiring. Use the one that switches air from...
Forum: Brakes
03-15-2018, 03:12 AM
Replies: 32
Views: 816
Posted By Twin_Turbo

Re: Do you have to bench bleed the master?

No. Hook it up. Fill the master and crack open front and rear bleeder on the longest lines (especially front)

Then use a sucker type bleeder to get all the air out. Only after do the pedal...
03-11-2018, 11:08 AM
Replies: 406
Views: 78,138
Posted By Twin_Turbo

Re: 1982 Trans Am, it needs some lovin too

Yessss... it runs

https://youtu.be/BdjnFzBaw00

https://youtu.be/4hkL_cKEILk
03-10-2018, 05:40 AM
03-08-2018, 10:46 AM
Replies: 406
Views: 78,138
Posted By Twin_Turbo

Re: 1982 Trans Am, it needs some lovin too

Didnt think it would fit either thats why I have a mast pan. Thing looks like it belongs in there how tight of a fit it is.
Forum: Electronics
03-08-2018, 05:30 AM
Replies: 8
Views: 196
Posted By Twin_Turbo

Re: Power out at turning ignitionkey - 91 Firebird

starter won't spin, dash goes out... won't fire up :)
03-08-2018, 05:30 AM
Replies: 23
Views: 336
Posted By Twin_Turbo

Re: 5.7 Vortec + LS7 Lifters PROBLEM

sounds like an oil control or oil starvation issue and the rod furthest from the pump going out. By any chance one of the front lifters was the one that locked up? How is the oil control in your...
Showing results 1 to 50 of 498
 


 
Forum Jump

Advertising
Featured Sponsors
Vendor Directory

Contact Us Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.