[CA] Sold: SLP Siamesed Runners + Intake
#1
Sold: SLP Siamesed Runners + Intake
Sold
Selling stock Intake base, original slp runners with the one siamesed side, vette fuel rails with 9th injector, and ported plenum. Prefer to sell together for $600 + shipping.
If just interested in runners, $500 shipped.
If just interested in runners, $500 shipped
Last edited by acesena4; 12-15-2017 at 03:59 PM. Reason: Sold
#2
Supreme Member
iTrader: (8)
Join Date: Oct 2001
Location: Il
Posts: 11,687
Received 745 Likes
on
505 Posts
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Re: SLP Siamesed Runners + Intake
These are the good ones!
#6
Re: SLP Siamesed Runners + Intake
I'm not sure about a comparison. I'd ask someone well versed in SLP's products and/or TPI to chime in on how much better they are, if at all.
These are the ones with one tube fully divided. You can sort of tell in the images above. The runners on the left are one, and the ones on the right have about an inch removed. This is how they came from SLP. No work has been done to them.
What set up do you have now?
These are the ones with one tube fully divided. You can sort of tell in the images above. The runners on the left are one, and the ones on the right have about an inch removed. This is how they came from SLP. No work has been done to them.
What set up do you have now?
#7
Member
iTrader: (4)
Re: SLP Siamesed Runners + Intake
I have the other style runners on an Accel base... Did a little knife edge on the dividers and also siamesed the plenum to the runners. "Feels" like it's still pulling well over 5000 rpm, but no way to know without a dyno run. Wouldn't mind having your runners just to have them around, but would really like to hear from someone who's run both...
Trending Topics
#8
Re: SLP Siamesed Runners + Intake
That sounds like a good setup. I had these on a stock base. For me, they were really for highway fun. The car pulled further than with the stock runners by far. They increased my top end, just not sure how much since I never took it on a dyno. Also, I didn’t notice any low end loss, which I found surprising.
#9
Re: SLP Siamesed Runners + Intake
Here's a page TTOP posted some time ago that describes them better. Second image.
https://www.thirdgen.org/forums/alte...ml#post5141237
https://www.thirdgen.org/forums/alte...ml#post5141237
#11
Member
Re: SLP Siamesed Runners + Intake
I'll take the runners , let me know where to send the money.