I have a few parts For Sale - Third Generation F-Body Message Boards


Southern California Area Southern California Members.

I have a few parts For Sale

Reply
 
Thread Tools Search this Thread
Old 05-08-2018, 01:30 PM   #1  
Supreme Member
Thread Starter
iTrader: (7)
 
Dyno Don's Avatar
 
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,359
Car: '90 Trans [email protected]
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73


I have a few parts For Sale

Garage clean out....

I will not ship large parts...pickup only

1 Four inch cat back single outlet Flowmaster muffler assembly $200

1 '85- '89 Gas tank ( very clean) $50

2 sets of factory 3.23 ten bolt gears $40 each

1 set 3.27 9 bolt gears $40

1 set of 4.10 gears ten bolt $40

HEI coil in cap distributor $ 40

1 700R4 trans core $200

2 '91-92 Camaro rear wheels $60

2 '87 Manual steering columns $100 each

2 drilled and slotted front rotors $40

1 Flowmaster 3"x 2 outlet muffler $20

1 set Edelbrock headers /w my custom Y-pipe $200
I also have the cat back w/flowmaster muffler. $75

1 '89 305 LB9 long block $100

1 set of Hawks ram air boxes $70

1 set stock lower control arms $40

1 2.77 9-bolt rear end (Free)
Attached Thumbnails
I have a few parts For Sale-dcp_1505.jpg   I have a few parts For Sale-dcp_1502.jpg  

Last edited by Dyno Don; 08-01-2018 at 04:33 PM.
Dyno Don is offline   Reply With Quote
Old 05-16-2018, 04:47 PM   #2  
Supreme Member
Thread Starter
iTrader: (7)
 
Dyno Don's Avatar
 
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,359
Car: '90 Trans [email protected]
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73


Re: I have a few parts For Sale

Headers & Y-pipe
Attached Thumbnails
I have a few parts For Sale-dcp_1502.jpg   I have a few parts For Sale-dcp_1503.jpg  
Dyno Don is offline   Reply With Quote
Old 05-16-2018, 04:57 PM   #3  
Supreme Member
Thread Starter
iTrader: (7)
 
Dyno Don's Avatar
 
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,359
Car: '90 Trans [email protected]
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73


Re: I have a few parts For Sale

Cat back
Attached Thumbnails
I have a few parts For Sale-dcp_1504.jpg  
Dyno Don is offline   Reply With Quote
Old 05-17-2018, 09:25 AM   #4  
Member
 
ARAMOS3's Avatar
 
Join Date: Oct 2006
Location: PARAMOUNT, CA
Posts: 101
Car: 1989 IROC-Z, 1986 IROC-Z
Engine: 350 TPI, 305 TPI
Transmission: 700R


Re: I have a few parts For Sale

Even though the headers have the air tubes I am assuming they are not smog legal in California.
ARAMOS3 is offline   Reply With Quote
Old 05-17-2018, 09:56 AM   #5  
Supreme Member
Thread Starter
iTrader: (7)
 
Dyno Don's Avatar
 
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,359
Car: '90 Trans [email protected]
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73


Re: I have a few parts For Sale

Quote:
Originally Posted by ARAMOS3 View Post
Even though the headers have the air tubes I am assuming they are not smog legal in California.
Yes they are.
Dyno Don is offline   Reply With Quote
Old 06-18-2018, 04:28 PM   #6  
Supreme Member
Thread Starter
iTrader: (7)
 
Dyno Don's Avatar
 
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,359
Car: '90 Trans [email protected]
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73


Re: I have a few parts For Sale

^^^^Bump
Dyno Don is offline   Reply With Quote
Old 07-13-2018, 02:04 PM   #7  
Junior Member
 
Join Date: Feb 2018
Location: Detroit mi
Posts: 64

Re: I have a few parts For Sale

Do U still have the set of lower control arms
Thirdvert89 is offline   Reply With Quote
Old 07-14-2018, 04:03 PM   #8  
Supreme Member
Thread Starter
iTrader: (7)
 
Dyno Don's Avatar
 
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,359
Car: '90 Trans [email protected]
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73


Re: I have a few parts For Sale

Yes I do.
Dyno Don is offline   Reply With Quote
Old 07-15-2018, 04:32 PM   #9  
Junior Member
 
Join Date: Feb 2018
Location: Detroit mi
Posts: 64

Re: I have a few parts For Sale

Would u be able to ship to me in Las Vegas 89147
Thirdvert89 is offline   Reply With Quote
Old 07-17-2018, 10:50 AM   #10  
Supreme Member
Thread Starter
iTrader: (7)
 
Dyno Don's Avatar
 
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,359
Car: '90 Trans [email protected]
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73


Re: I have a few parts For Sale

Yes I will check on shipping costs.
Dyno Don is offline   Reply With Quote
Old 08-01-2018, 12:02 PM   #11  
Supreme Member
Thread Starter
iTrader: (7)
 
Dyno Don's Avatar
 
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,359
Car: '90 Trans [email protected]
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73


Re: I have a few parts For Sale

Shipping UPS is $35
Dyno Don is offline   Reply With Quote
Old 08-01-2018, 03:48 PM   #12  
Member
 
Go Blue's Avatar
 
Join Date: Sep 2017
Location: Huntley, IL
Posts: 222
Car: 88 Chevy IROC Z28
Engine: 5.7L TPI
Transmission: 700R4

Re: I have a few parts For Sale

How many miles on the 3.73 gears? How much shipped to 60142? Any posi units as I think mine just crapped out last week, but I haven't had the time to take the Rear cover off to investigate. I have a 2.77 limited slip gear right now that is original to my 88 IROC according to the PO.
Go Blue is offline   Reply With Quote
Old 08-01-2018, 04:30 PM   #13  
Supreme Member
Thread Starter
iTrader: (7)
 
Dyno Don's Avatar
 
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,359
Car: '90 Trans [email protected]
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73


Re: I have a few parts For Sale

Bad news, I just assembled the gears in a complete rear end w/disc brakes and posi.
Dyno Don is offline   Reply With Quote
Old 08-01-2018, 04:32 PM   #14  
Member
 
Go Blue's Avatar
 
Join Date: Sep 2017
Location: Huntley, IL
Posts: 222
Car: 88 Chevy IROC Z28
Engine: 5.7L TPI
Transmission: 700R4

Re: I have a few parts For Sale

What about the 3.23 gears and a posi (if possible)??
Go Blue is offline   Reply With Quote
Old 08-01-2018, 04:39 PM   #15  
Supreme Member
Thread Starter
iTrader: (7)
 
Dyno Don's Avatar
 
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,359
Car: '90 Trans [email protected]
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73


Re: I have a few parts For Sale

Quote:
Originally Posted by Go Blue View Post
What about the 3.23 gears and a posi (if possible)??
Those gears are for 3 series posi, I don't have one.

I have a complete rear /no brakes w/3.42 posi
might be expensive to ship.
Dyno Don is offline   Reply With Quote
Old 08-01-2018, 09:21 PM   #16  
Junior Member
 
Join Date: Sep 2003
Location: Santa Maria, Calif.
Posts: 46
Car: 1998 Firebird Formula M6
Engine: LS6 installation finished 8-17-2011
Transmission: T-56
Axle/Gears: Stock 3.42 Ratio


Re: I have a few parts For Sale

I didn't have much luck trying to get rid of a 700R4 core I posted here some time ago. I wound up selling it for scrap. What I did do was sell the tail housing on Ebay. There's a market for those darn things! You might keep that in mind.
6998poncho is offline   Reply With Quote
Old 08-02-2018, 11:52 AM   #17  
Moderator
iTrader: (1)
 
Kevin91Z's Avatar
 
Join Date: Jul 1999
Location: Disneyland, SoCal
Posts: 10,848
Car: 1991 Camaro Z28
Engine: 355 TPI siamesed runners
Transmission: LT1 T56
Axle/Gears: 9-Bolt 3.70


Re: I have a few parts For Sale

Quote:
Originally Posted by Go Blue View Post
How many miles on the 3.73 gears? How much shipped to 60142? Any posi units as I think mine just crapped out last week, but I haven't had the time to take the Rear cover off to investigate. I have a 2.77 limited slip gear right now that is original to my 88 IROC according to the PO.
Where do you see 3.73 gears for sale?

And if you have a 9-bolt you can't use 3.73 10-bolt gears. You could use the 3.27 9-bolt gears he has, but you need to find a 3-series 9-bolt posi unit to go with them, too.
Kevin91Z is offline   Reply With Quote
Old 08-02-2018, 05:08 PM   #18  
Member
 
Go Blue's Avatar
 
Join Date: Sep 2017
Location: Huntley, IL
Posts: 222
Car: 88 Chevy IROC Z28
Engine: 5.7L TPI
Transmission: 700R4

Re: I have a few parts For Sale

I found out today that I have a 9 bolt Borg Warner posi that bit the dust. So Iím looking for a replacement posi and probably 3.42ish gears since 3.73 doesnít work so well on the highway and I use the highway often.
Go Blue is offline   Reply With Quote
Reply

Related Topics
Thread Thread Starter Forum Replies Last Post
[For Sale] I have a few LS parts for sale. Cam, heads, etc... FIRECHICKEN LSX and LTX Parts 0 09-28-2014 07:09 PM
[CA] ****89 iroc parts everything must go parts parts, floors qt panels parts parts***** juanillox8 Exterior Parts for Sale 39 09-26-2010 04:52 PM
ls1 parts, lt1 camshaft, 5spd plate, and a few parts for sale z28gsxr Southern California Area 25 01-12-2010 09:47 AM
have order the hedman headers!but have a few questions!! Iroc-Dennis Exhaust 6 12-11-2007 04:19 PM
have a few parts for sale.... crawlin 25th NW Indiana and South Chicago Suburb 23 05-26-2005 04:19 PM


Go Back   Third Generation F-Body Message Boards >

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Advertising
Featured Sponsors
Vendor Directory

1982 Camaro '82 || 1983 Camaro '83 || 1984 Camaro '84 || 1985 Camaro '85 || 1986 Camaro '86 || 1987 Camaro '87 || 1988 Camaro '88 || 1989 Camaro '89 || 1990 Camaro '90 || 1991 Camaro '91 || 1992 Camaro '92


All times are GMT -5. The time now is 02:16 PM.


© 2018 MH Sub I, LLC dba Internet Brands
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
 
  • Ask a Question
    Get answers from community experts
Question Title:
Description:
Your question will be posted in: