TBI conversion
06-01-2008, 11:57 PM
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Dec 2007
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
TBI conversion
I am converting my car to TBI I am just about done but have a couple problems I am not sure where the Red and White wire on the injectors need to go? Can the system work without a knock sensor if so how if not any suggestions on where to put it.
06-02-2008, 03:59 AM
#2
Member
Join Date: Sep 2006
Location: alabama
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 camaro rs
Engine: 350 tbi/416's/comp xe268
Transmission: 700r4
Axle/Gears: 3.42
Re: TBI conversion
ok for starters the knock sens must be on and it goes on pass side of motor below head. wireing... hmm mine was yellow green for pass side and red green on driver i think id have to check
Thread
Thread Starter
Forum
Replies
Last Post
2012sergen11
Engine/Drivetrain/Suspension Wanted
6
10-13-2015 07:38 PM
