Do these TBis get their adjustments like old school SBC where you gotta turn it for the degrees. or does the computer adjust the timing?? mine isnt vaccuum advance or anyhting, just an ign module and the rotor lol. just wondering if i can set the timing like i do with old school SB/BBcs or not

 

Yes, timing light and turn the distributer, just remember to unplug the EST connector before https://www.thirdgen.org/forums/sear...archid=4384402

 

ok thankyou...... bad link though

 

Sorry, the page with the search results does not work in the link.

Can type, "location EST connector" in the search feature, in case you are not familiar with it.

 

yeup ill check it out when i get there. i just today got the motor to spin over on the key

 

Distributor position sets the base timing, advance is controlled by the ECM.

 

This is from the technical articles section. You should go look around in there, lots of good stuff
https://www.thirdgen.org/settingtiming