engine swap
Thread Starter
Junior Member
Joined: May 2002
Posts: 4
Likes: 0
From: Mountain Home AR
check this out
OK here goes, Ihave A 87 iroc with the tune port 305, what I want to know is can I take a 1972 350 block and bolt all my tune
port acessories like the cam and distributor and the heads,because I know if all that will bolt up then so will the injection system. Without any problems? The reason I'm posting here instead of the TPI section is cause I read their replys to other posters and it seemed to me all they were doing was guessing and giving their opinons, where you guys sound like you actually know what your talking about(now I'll get flak from the other guys if I go in there and post)
port acessories like the cam and distributor and the heads,because I know if all that will bolt up then so will the injection system. Without any problems? The reason I'm posting here instead of the TPI section is cause I read their replys to other posters and it seemed to me all they were doing was guessing and giving their opinons, where you guys sound like you actually know what your talking about(now I'll get flak from the other guys if I go in there and post)
Last edited by killer6211; May 21, 2002 at 07:26 PM.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM