question about valve covers...
Thread Starter
Member
Joined: Dec 2001
Posts: 439
Likes: 0
From: Houston, Tx.
question about valve covers...
ec heads have a center bolt pattern for valve covers. And I have some heads that are Miloden's and they have 2 bolts on either side of them. 4 bolts total on each head. I was wondering if there was a way I could use these. Is there something Im missing, or a conversion kit I can buy. Thanks, would really like to use them, but dont know if I can... Here is a pic of them.... Thanks,
TGO Supporter
Joined: Aug 1999
Posts: 14,811
Likes: 1
From: Jackson County
you might want to try this again you're not very clear, or i'm a little dense. you have center bolt heads and want to use peremeter bolt valve covers, not heads right? i believe someone does make an adapter for this. call 1-800-345-4545 and tell them waht you're wanting to do.
Thread Starter
Member
Joined: Dec 2001
Posts: 439
Likes: 0
From: Houston, Tx.
haha, ok I dont know where that number goes too but ok? No, sorry I will be a little more clear. I have centerbolt style Vortec heads, and I have some perimeter valve covers, and I want to put them on, but *** is telling me no. 
Haha, help please.
Haha, help please. 
Senior Member
Joined: Jun 2002
Posts: 558
Likes: 0
From: Bowling Green KY
Car: 87 IROC-Z
Engine: 350ci
Transmission: T-5
Go to www.nextgenparts.com They have an adapter kit. Look under engine components.
Senior Member
Joined: Jul 2002
Posts: 583
Likes: 1
From: under the hood
$165.00 dollars ???? Yeah right! Go to www.jegs.com and get the proform adapter kit for less than half that price!!
Thread
Thread Starter
Forum
Replies
Last Post