i am rebuilding my 350. i wanted to know if the eagle sir rods are any good and also if gm's pm rods are any good, i have heard good and bad stories about both. i was gonna have my crank turned .10/.10 if it needs it, if it needs more, i was gonna get another crank. any suggestions on that? i am probably only gonna be pushin about 350 horse with like a 150 shot on top of that. would a stock cast crank turned .10/.10 handle that? if not where is a good place to get a crank cheap? how much do you think it would cost to get my block bored .030, new bearings and freeze plugs, honed with torque plate, crank turned, balanced, decked and hot tanked and have the machine shop do all of my clearances? thanks