After getting all my mods done to my car my oil pressure is running 60 above is that bad? I'm thinking that the gauge broken ? Please help me out thanks

 

Rather than trust the dash guage, you could verify its accuracy with a separate guage.

What "mods"? Moreover, what viscosity lubricant is in the sump?

 

You might want to check the wiring and connectors for that sensor as well. I know mine is rigged together, and my gauge bounces around quite a bit. If the sensor wire gets grounded to the block or your exhaust (headers that may have melted the sensor wire?) etc then I think the gauge is gonna read 60+ all day.

 

mods from

SPDC Vortec Head Kit, Roller, TPI Intake, Headers

1.6 rockers arm
molly pushrods
Edelbrock short headers
zz4 cam
comp cam lifters

Where is sensor wire at? Do you have a pic?

Thanks

 

it should be on connected to the oil pressure sending unit which should be located on the divers side rear right by the back of the intake manifold a tad right of the driver side head.

 

ok i put a new one thanks for your help