Where to set my timing???
Thread Starter
Member
Joined: May 2004
Posts: 278
Likes: 0
From: USA
Car: Trans Am
Engine: 305 to 350 to 383 to BOOM!!!
Transmission: 5-speed
Axle/Gears: 3.73 10-bolt
Where to set my timing???
I got a 350 mostly stock engine
Cam is 465 intake 488 exhust
Duration is 224 / 234 @.05"
I got a Demon 650 D.P. on top of a mostly stock intake...is raised a bit
I was just wonder what I should set my timing at
Thanks in Advance.
Cam is 465 intake 488 exhust
Duration is 224 / 234 @.05"
I got a Demon 650 D.P. on top of a mostly stock intake...is raised a bit
I was just wonder what I should set my timing at
Thanks in Advance.
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
Hold the throttle open to 3000RPM or so, and turn the distributor to 36* timing. Go back to idle, and reset your idle speed. Check the timing, probably around 16* or so. Leave vacuum advance on ported. Should work well.
Thread
Thread Starter
Forum
Replies
Last Post
