Tpi issues
Tpi issues
I have an 89 iroc with 305 tpi 5 speed. put fuel injection back in car after it was converted to carb car will run but will have to spray starting fluid in throttle body to get to start sometimes,and the idle is erratic. also when i try to drive it it bucks a little and stalls whenever i go to slow down also it backfires occasionaliy.i have replaced iac, new distributor, ecm, plugs, all injectors getting good signal, catalytic converter removed, no air pump, no charcoal canister. i am out of ideas and any help with be appreciated
Last edited by 89_Irocz; Sep 21, 2011 at 01:28 AM.
Senior Member
iTrader: (3)
Joined: Aug 2008
Posts: 614
Likes: 0
From: Memphis, TN
Car: 1992 z28 Purple Haze
Engine: 5.7L Tuned Port Injection
Transmission: 700R4
Axle/Gears: 3.23 both spinning
Re: Tpi issues
Is the electric factory fuel pump still in it and hooked up? I would think if it had been carbed, the fuel pump was unhooked and an old style pump put in so as not to drown the carb. Big difference in fuel pressure between a carb and TPI.
Re: Tpi issues
the in the tank pump is hooked up it was running fuel pressure regulator to make it 4 psi for carb. i fixed the erratic idle and stalling turns out it was bad egr valve but wont start at all unless starting fluid is sprayed in throttle body
Senior Member
iTrader: (3)
Joined: Aug 2008
Posts: 614
Likes: 0
From: Memphis, TN
Car: 1992 z28 Purple Haze
Engine: 5.7L Tuned Port Injection
Transmission: 700R4
Axle/Gears: 3.23 both spinning
Re: Tpi issues
Have you checked the fuel pressure now that you have put everything back to TPI? If so, what is it running? Also, not sure, but I think the 89's still had the "cold start" injector. Could be wrong, so maybe another forum member might know, but if it does, there could be an issue with that????
Member
Joined: May 2010
Posts: 463
Likes: 0
From: Houston Area
Car: 1989 IROC-Z
Engine: 355, 6.0 (LQ4) soon
Transmission: 700R4
Axle/Gears: Borg Warner 2.77 for now
Re: Tpi issues
89s didn't have cold start, check the fuel pressure as mentioned and try swapping out the MAF if you can or just unplug it while its running, if it runs worse it's still good. Are all of the sensors hooked up and hooked up right? Might just be your temp sensor, might not, pull the codes and see what turns up there too
Senior Member
iTrader: (3)
Joined: Aug 2008
Posts: 614
Likes: 0
From: Memphis, TN
Car: 1992 z28 Purple Haze
Engine: 5.7L Tuned Port Injection
Transmission: 700R4
Axle/Gears: 3.23 both spinning
Re: Tpi issues
I was off base with that one. Thanks for the correction stealthroc89!
Thread
Thread Starter
Forum
Replies
Last Post
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 25, 2015 11:49 PM
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 12, 2015 03:41 PM





