vccum leak help
Thread Starter
Senior Member
Joined: Jun 2011
Posts: 939
Likes: 0
From: Detroit, MI
Car: 1987 IROC-Z red t-top
Engine: Nothing much
Transmission: I wish t56
Axle/Gears: 9bolt 3.27 4sale
vccum leak help
okk is a HSR on 113 heads its a lip on the head intake, intake is 1205 heads are stock. Ok today I went to pull the plunem off and it had oil, wet carbon build up more so the back with some ports by the gaskets wet too. Just three in he back both on left rear 1 om the left away from the dizzy
Thread Starter
Senior Member
Joined: Jun 2011
Posts: 939
Likes: 0
From: Detroit, MI
Car: 1987 IROC-Z red t-top
Engine: Nothing much
Transmission: I wish t56
Axle/Gears: 9bolt 3.27 4sale
Re: vccum leak help
Here are some pics to help, my fingers are on the 1s wet
This is how it looks in two ports
And this is the diff between the front and the back of the plunem
Is this where the leak is or I'm running to rich/lean. The plunem smell like bernt oil
This is how it looks in two ports
And this is the diff between the front and the back of the plunem
Is this where the leak is or I'm running to rich/lean. The plunem smell like bernt oil
Joined: Jun 2002
Posts: 13,576
Likes: 30
From: Harford County, MD
Car: camaro sportcoupe
Engine: 7.0L
Transmission: G-Force GF5R
Axle/Gears: Moser 9"
Re: vccum leak help
bad valve seals? does the 113's have positive locking seals on it or just o-ring type?
what's the pcv setup look like?
what's the pcv setup look like?
Thread
Thread Starter
Forum
Replies
Last Post