Throttle cable end snapped/replaced - crank no start
Throttle cable end snapped/replaced - crank no start
I have a 90 Camaro RS that is my daily driver.
As I was giving it some gas to get up to highway speed it died mid drive.
We found that the Throttle cable end had snapped, so we ordered the replacement.
Since replacing end the car cranks but wont start.
It looks like all of the elctrical components are working, headlights, accessory etc.
Could this be sensor related? Any ideas?
As I was giving it some gas to get up to highway speed it died mid drive.
We found that the Throttle cable end had snapped, so we ordered the replacement.
Since replacing end the car cranks but wont start.
It looks like all of the elctrical components are working, headlights, accessory etc.
Could this be sensor related? Any ideas?
Supreme Member




Joined: Jan 2008
Posts: 1,336
Likes: 567
Car: 1986 IROC Z
Engine: 5.0 TPI
Transmission: 700R4
Axle/Gears: 3.23 Posi
Re: Throttle cable end snapped/replaced - crank no start
Supreme Member

Joined: Jan 2000
Posts: 1,218
Likes: 97
From: Mississauga, Ontario Canada
Car: 1987 GTA
Engine: 5.7
Transmission: T5WC
Axle/Gears: 3:27
Re: Throttle cable end snapped/replaced - crank no start
The snapped cable should not have shut you down. You'd be stuck at idle. Did something let go on your throttle body?
Thread
Thread Starter
Forum
Replies
Last Post
zenish
Transmissions and Drivetrain
2
Nov 30, 2014 05:57 PM
wiggin
Tech / General Engine
1
Dec 19, 2009 05:20 PM
SS ninja
Alternative Port EFI Intakes
23
Apr 29, 2009 11:12 AM




