OE rockers
Thread Starter
Member
Joined: Aug 2021
Posts: 418
Likes: 66
From: Central Michigan
Engine: SBC Dart 400 Holley 750 Carb
Transmission: 700R4
Axle/Gears: 28 spline 323 gears
OE rockers
I have a 91 Z 350 TPI that has Crane roller rockers. Stock everything else. I am building a 400 sbc with aluminum heads. I would like to put the 350 Crane rockers on the 400 and then put some used OE rockers on the 350. I will be driving the 350 for several months before the swap. Is putting used OE rockers on the 350 a bad idea or is it ok? Will it cause the push rods to wear out prematurely? Or any other problems?
Joined: Dec 2004
Posts: 16,920
Likes: 1,016
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: OE rockers
Sa no guide plates elongated holes for push rods.
non sa run hardened pushrods and guide plates.
non sa run hardened pushrods and guide plates.
Thread Starter
Member
Joined: Aug 2021
Posts: 418
Likes: 66
From: Central Michigan
Engine: SBC Dart 400 Holley 750 Carb
Transmission: 700R4
Axle/Gears: 28 spline 323 gears
Re: OE rockers
Ahh. Sometimes the obvious isn't so obvious. New rockers are on the way. Thank you.
Thread
Thread Starter
Forum
Replies
Last Post