File fitting piston rings with torque plate installed
Thread Starter
Member
Joined: Jul 2013
Posts: 179
Likes: 46
From: Green bow Ala-freakin-bama
Car: 88 Iroc
Engine: 388 Vortec Pro-Flo 4 Small Block
Transmission: T56
Axle/Gears: 3.77 to 1
File fitting piston rings with torque plate installed
I don’t see any information on this topic but if you wanna squeeze every last bit of power out I recommend torque plate honing your cylinders and performing the file fitting of the rings while the torque plates are installed. This is straight from total seal’s instructions. Just wanted to share.
Happy motoring!
Last edited by Tombowman89; Nov 6, 2023 at 07:29 PM.
Thread
Thread Starter
Forum
Replies
Last Post
8t2 z-chev
Tech / General Engine
6
Apr 28, 2013 11:45 AM