Fan switch
Thread Starter
Supreme Member
iTrader: (2)
Joined: Jan 2002
Posts: 9,962
Likes: 5
From: Moorestown, NJ
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
Fan switch
Just out of curiosity, should a fan switch have rtv sealent applied to it prior to install? I know silicone makes a good insulator. Would this interfer w/ the switch being able to close the circuit for the relay?
Supreme Member
Joined: Jul 2001
Posts: 3,974
Likes: 0
From: Pueblo Co
Car: 1989 C4
Engine: L98
Transmission: 700r4
Axle/Gears: 307
A little bit wont hurt it but it wont do much and is ugly. If your concerned about a leak because some threads are screwed up try some locktight or if there really bad just get some teflon tape from a hardware store.
SSC
SSC
Thread
Thread Starter
Forum
Replies
Last Post
FormulasOnly
Tech / General Engine
3
Sep 10, 2015 09:07 PM