Serpentine setup with a carb?
Thread Starter
Member
iTrader: (1)
Joined: Feb 2001
Posts: 155
Likes: 0
From: Wisconsin
Car: 79 Monte Carlo
Engine: 406
Transmission: 2004-R
Axle/Gears: Phord 9 inch/3.90
Serpentine setup with a carb?
I know I have seen pictures of ths done before, but I cannot find where they were. If any of you guys have done it, what did you do for a thermostat housing? My housing points my hose right at the alternator. Any thoughts?
Thread Starter
Member
iTrader: (1)
Joined: Feb 2001
Posts: 155
Likes: 0
From: Wisconsin
Car: 79 Monte Carlo
Engine: 406
Transmission: 2004-R
Axle/Gears: Phord 9 inch/3.90
What't the serpentine setup have to do with the carb ? lol
It has to do with the fact that the thermostat housing is set back further on the carb manifold than the TPI one. And typical thermostat housings run the radiator hose right over the top of the alternator. I thought it was pretty self explanatory in my original post. Jeez
It has to do with the fact that the thermostat housing is set back further on the carb manifold than the TPI one. And typical thermostat housings run the radiator hose right over the top of the alternator. I thought it was pretty self explanatory in my original post. Jeez
Thread
Thread Starter
Forum
Replies
Last Post
Billy Decker
Engine/Drivetrain/Suspension Wanted
0
Sep 4, 2015 03:46 PM
GeneralIesrussi
Tech / General Engine
0
Sep 3, 2015 03:23 AM