I have a set of aluminum L98's that I want to sell from an old project,and the studs/ springs have a little bit of rust on them...should I try to clean that up,and if so what is the best method,or should I just sell them bare?..
They have some port work done to them/with valve job,new valves...I'm selling them cheap anyways but wondering if I should even bother cleaning up the springs/studs....they are not that bad really...but I don't want to sell something that dosen't look good.

 

You can try a brass wire brush, the tooth brush sized ones. They won't hurt the alum and should be just fine for knocking off minor rust.
Also..check PM's.