Dyno numbers from last sat
Thread Starter
Senior Member
iTrader: (4)
Joined: May 2000
Posts: 588
Likes: 0
From: Oaks,Pa
Car: 89 IROC
Engine: 350 HSR
Transmission: modified 700R4
Axle/Gears: 3.42
Dyno numbers from last sat
This is on a Mustang Dyno: 195 rear wheel HP & 270 torque and the 1/4 mile pull was right on the time in sig
Thread Starter
Senior Member
iTrader: (4)
Joined: May 2000
Posts: 588
Likes: 0
From: Oaks,Pa
Car: 89 IROC
Engine: 350 HSR
Transmission: modified 700R4
Axle/Gears: 3.42
Those numbers are with the stock runners.Just got done reinstalling the SLP ported runners back on so in a few weeks gonna do the Dyno again to have a comparison.
Supreme Member
iTrader: (1)
Joined: Mar 2005
Posts: 1,171
Likes: 0
From: Hamilton
Car: 1990 IROCZ Camaro
Engine: 350 4bbl, 200cc Heads, 270hr Cam
Transmission: 700R4 w/ Trans-Go shift kit.
Axle/Gears: GM 10 bolt Posi
I would have expected more out of that setup, especially with the numbers you put down at the 1/4. Im sure youd open up alot more with a set of heads.
Thread Starter
Senior Member
iTrader: (4)
Joined: May 2000
Posts: 588
Likes: 0
From: Oaks,Pa
Car: 89 IROC
Engine: 350 HSR
Transmission: modified 700R4
Axle/Gears: 3.42
Originally Posted by GuitarJunki17
I would have expected more out of that setup, especially with the numbers you put down at the 1/4. Im sure youd open up alot more with a set of heads.
Supreme Member
Joined: Jan 2003
Posts: 2,043
Likes: 3
From: San Diego
Car: 1994 Trans Am
Engine: LT1
Transmission: Auto
Axle/Gears: 3.23
Yeah, something isn't right. I dynoed last spring 187whp and 267wtq with only the catback unbolted. The rest of the car was bone stock. My car is an auto '91 Lb9.
Thread
Thread Starter
Forum
Replies
Last Post
Springster
Tech / General Engine
2
Sep 13, 2015 01:38 PM
Doobie52
Engine/Drivetrain/Suspension Parts for Sale
0
Sep 11, 2015 06:19 PM
