V6 Discussion and questions about the base carbureted or MPFI V6's and the rare SFI Turbo V6.

startup problems

Thread Tools
 
Search this Thread
 
Old Jul 9, 2005 | 05:36 PM
  #1  
rogue393's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2005
Posts: 2
Likes: 0
From: Albuquerque, New Mexico
Car: 1986 Firebird
Engine: 2.8 l
startup problems

86 firebird 2.8 V6 where to start, Well it won't start after it has warmed up. It Turns over just won't light up. Spark is fine, this is definately a fuel issue but I am not a multiport injection person (old carb man). Put in new fuel pump but it wasn't the problem. Definately not ignition problem as I have replaced almost all of it from the switch out. Gets spark and runs fine till I shut her down. After setting an hour or two it starts and runs fine again. Tried a no-no and heated her up till it wouldn't start then I used a touch of starting fluid on it and it fired right up. Tried this four times and it worked ever time. Once started it has no problem and when it is cold it has no problem starting. Any suggestions?

Last edited by rogue393; Jul 9, 2005 at 05:38 PM.
Reply
Old Jul 9, 2005 | 07:01 PM
  #2  
87blueracr's Avatar
Banned
 
Joined: May 2005
Posts: 499
Likes: 0
From: jacksonville, fla
Car: 1987 camaro & 70 mustang
Engine: 2.8l & built 351C
Transmission: borg warner T-5
clean the jets, sounds like the jets are cloggeg a little. it may also be the diaphram in the carb itself that has a slight tear in it, hit the gas a couple of times when it is hot before you go to start it up. this is the only advise that i can give you without me actually seeing the thing do this!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
pjsparts
Tech / General Engine
11
Oct 29, 2025 06:39 PM
88rscamar0
Transmissions and Drivetrain
5
Sep 23, 2015 09:08 PM
IROCtometal
TPI
3
Sep 9, 2015 10:01 AM
383cam
Electronics
5
Sep 9, 2015 06:01 AM
andy74
Electronics
2
Sep 3, 2015 08:41 AM




All times are GMT -5. The time now is 02:51 PM.